Mini Digital Turbine Flowmeter Diesel Fuel Flow Meter 10‑200L 1" NPT

1、Modular design makes it suitable for use with output modules, sensors and remote transmitters.

2、Compact structure, easy to install.

3、Intuitive clear reading, high reliability, measuring accuracy is ±1%.

4、High-definition displays show both instantaneous and cumulative flow.

5、Can be widely used to measure diesel, kerosene, gasoline, etc.

Description: This digitalturbine flow meter has modular design, high accuracy, compact size and stable performance. Easy to replace and maintain internal components. Suitable for use with output modules, sensors and remote transmitters. Features:

Modular design makes it suitable for use with output modules, sensors and remote transmitters.

Compact structure, easy to install.

Intuitive clear reading, high reliability, measuring accuracy is ±1%.

High-definition displays show both instantaneous and cumulative flow.

Can be widely used to measure diesel, kerosene, gasoline, etc.

Specification: Operating voltage: 2.3-3.3V Battery type: 2 x AAA LRO3 batteries Thread size: 1inchNPT Repetition: ±0.5% Measure accuracy: ±1% Maximum working pressure: 20BAR Flow range: 10-90L / Min, 25-150L / Min, 35-250L / Min Single count: 0.00-9999.9 Total cumulative count: 0-999999

Mistakes count: 0.1000-9.9999 Working temperature: -10°C ~ +60°C(14°F~140°F) Standby time: 2 years Application: Diesel, kerosene, gasoline Color: Red, Blue(Optional) Weight: 371g Malfunction and solution:

The flow meter is not accurate.

1. The method

of field calibration is not correct.

Calibrate

again.

2. The flow rate on the meter is below the

lowest.

Increase

the flow rate.

3. The flow meter is blocked by the dry liquid.

Take

out the impeller and clean it carefully and make sure the impeller turns

freely.

4. The impeller is wrapped by the sealing

material.

Remove

the meter and make sure the impeller turns freely.

5. Too close to the impeller.

Install

properly.

6. Too close to the motor or electronic noise

environment

Install

properly.

The reading numbers faded or blanked out.

1.Battery

is exhausted or not connected

Check

the batteries or even replace them.

Flow rate is normal but the meter can not count. Press

the button of DISPLAY, the meter starts.

1.

Field calibration is not correct.

Calibrate

again.

2. The impeller is blocked or

damaged.

Remove

the meter and make sure the impeller turns freely.

3.The impeller is wrapped by the sealing

material.

Remove

the meter and make sure the impeller turns freely.

Flow rate is low and the meter can not count. Press

the button of DISPLAY, the meter starts.

1.

The flow meter is blocked by the dry liquid.

Take

out the impeller, clean it carefully and make sure the impeller turns freely.

2. The flow rate on the meter is below the

lowest.

Increase

the flow rate.

The meter can not calibrate.

1.

Circuit board is break down.

Replace

the circuit board.

2. Button is fail to press.

Replace

the circuit board.

Package List: 1 x Turbine Flow Meter1 x Manual

Note:Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering.