Mist Maker 12 Head Ultrasonic Mister 5000ml/H, w/Float, 300W for Halloween, Plant Greenhouse Humidify, Pond Decoration, Water Humidifier, Only Water Use, Instant Mist, Easy to Install

Application

With an indoor applicable area of 6㎡/ 64.58ft² and an outdoor applicable area of 4㎡/ 43.06ft², it can be used for decoration to create a special atmosphere for stages, artificial landscapes, gardens, Halloween, and other holiday parties; it can also provide proper humidity for insectivorous plants, fungi, and mushroom rooms. In addition, it can effectively remove dust and smoke from the air in an electrostatic manner.

Specifications

Model: SG-12T48

Color: Silver

Housing Material: 304 Stainless Steel

Atomization Method: Ultrasonic

Power: 300W

Voltage: 220V

Plug: UK Standard

Working Voltage: DC48V

Working Current: 6.25A

Frequency: 1.7MHz

Working Temperature: 5-55℃

Waterproof Rating: IP67

Applicable Water Quality: Conventional Tap Water, Electrolytic Water, Pure Water

Humidifying Capacity: 5kg(11.02lbs) / h

Indoor Coverage Area: 2.5m/ 8.2ft

Outdoor Coverage Area: 1.5m/ 4.92ft

Atomization Plate Size: 32*8.2*6.2cm/ 12.6*3.23*2.44in

Package Size: 39*16*18.5cm/ 15.35*6.3*7.28in

Net Weight: 3kg/ 6.61lbs

Gross Weight: 4.2kg/ 9.26lbs

Package Included
1* 12-head Atomization Plate

1* Waterproof Power Supply

2* Buoy Parts

All Accessories Needed

Notes
1. Please place the power supply in a ventilated and cool place, avoid immersing the power supply in water for a long time to work or exposing the power supply to the sunlight.

2. When using it for the first time, please adjust the buoyancy.

3. Please cut the middle foam into smaller pieces or add weight.

4. When using the mist maker, you need to be equipped with a power supply (output power ≥ 300W, output voltage of DC45V ± 3V); when using a toroidal transformer (to convert AC220V to AC36V), you also need to be equipped with a rectifier board (to convert AC36V to DC48V)

5. After the mist maker is connected to the power supply, please put it flat in the water with the atomization head facing up and fully submerged in the water before turning on the power. When the mist maker is operating with power on, please avoid taking out the mist maker upside down to avoid damage.

6. The water surface is about 1cm/ 0.394in above the water level sensor of the mist maker, the atomization effect is appropriate. If the water is too deep, please use the buoy.

7. Please note that the fog produced by the mist maker needs to be discharged by the fan to avoid fog stagnation on the water surface resulting in higher water temperature and shortening the life of the mist maker.

8. When more than one mist maker is in a container (interval of not more than 1m / 39.37in), each mist maker quality inspection shell needs to conduct each other to prevent electrical corrosion of the mist maker housing and damage to the mist maker.

9. After a long time of work, the shell and atomization piece surface will deposit scale, affecting the service life and atomization effect. It is recommended that the mist maker is gently scrubbed with a soft cloth and rinsed with water once every half month.

10. Please avoid damaging the water level switch during the mist maker installation process, so as not to cause the water level switch to malfunction and cause the mist maker to go out of control. This will cause the atomization piece dry burn and serious damage to the mist maker.