Oil drain pump extraction pump, liquid transfer

Features:

1. Widely used in general industrial equipment
2. Maximum pressure: 0.8 MPa
3. Ideal equipment for quick and clean oil changes
4. It operates by connecting the clamps to a 12V car battery
5. Connect the car battery to start and stop; easy to use

Specifications:

Description:
This oil extractor transfer pump uses a 12V mini self-priming pump to change engine oil in cars. It operates by connecting the clamps to a 12V car battery and is widely used in general industrial equipment, as this pump can not only pump oil, but can also pump hydraulic oil and other liquids. This is an ideal piece of equipment for quick and clean oil changes.
Features:
1. Widely used in general industrial equipment.
2. It operates by connecting the clamps to a 12V car battery.
3. An ideal piece of equipment for quick and clean oil changes.
4. Connect the car battery to start, turn it off, easy to use.
Specifications:
Rated Voltage: DC 12V
Rated Power: 60W
Maximum Pressure: 0.8 MPa
Maximum Flow Rate: 5 L/min
Pump Diameter: approx. 4.8 cm / 1.89"
Length: approx. 14.5 cm / 5.7"
Outlet pipe size (Dia. x L): approx. 11 mm x 140 cm / 0.43" x 55"
Inlet pipe diameter: approx. 8 mm and 6 mm / 0.31" and 0.24"
Inlet pipe length: approx. 100 cm / 39.37"
Cable length: approx. 30 cm / 11.8"
Clip length: approx. 8 cm / 3.15"
Main Color: Black
Application: Widely used in general industrial equipment, chemical equipment, shipbuilding, beverages, carpet and floor cleaning, water purification and treatment equipment, vehicle cleaning, agricultural spraying, pipelines, pressure, air cleaning, cooling, coal and metallurgical industries.
How to Use:
1. Start running the car engine for a while. When the oil temperature reaches approximately 50 degrees Celsius, begin pumping oil.
2. Connect the pump to the power supply, run it for a while, and observe if the inlet and outlet are normal.
3. Open the filler cap, remove the dipstick, and force the tube into the bottom of the seal until it is fully inserted. The tube should not move. 4. After pumping the oil, remove the tube, then run the pump for a while to pump out any remaining oil. Alternatively, pump water for a while until the pump head is clean. 5. If the pump hasn't been used for a long time, there may be no suction. Simply pour water into the pump and run it for a few minutes until all the air is expelled. Package includes: /> 1 x oil pump
1 x 11mm outlet hose
1 x 8mm inlet hose
1 x 6mm inlet hose
2 x clips
Note:
1. Please allow 1-3mm error due to manual measurement.Thank you for your understanding.
2. If you wish to connect this pump to mains power, you will need a power converter.
3. Please use when the engine is warm, the engine oil is hot and its viscosity is lower; it will be easier and faster to pump.
4. This product is not authorized to pump corrosive liquids, strong acids, or highly alkaline liquids.
5. Please note that the new and old types of this product will be sent randomly, and please ensure this is acceptable to you before ordering.