1. This series of products can be applied to rubber bands with a diameter of 7 to 7.5 mm.
2. Insert the rubber band from the end of the glue gun, send it to the barrel, connect the power supply and preheat it for 5 to 8 minutes. Press the trigger to extrude the floor and control the amount of glue.
3. During use, if an adhesive tape can not be used at a time, the adhesive tape does not need to be removed. The next time it is used, it can be connected and used directly after preheating for 5-8 minutes.
Order number: pp20w
glue gun model: 20W
Plug-in type: power supply
supply voltage: 110-220V
Power: 20 (w)
Field: DIY Application Handmade
Weight: 0.13 (kg)
Specifications: Length 13.5 * Width 11 * 2 cm
Glue gun: Thermofusible series
5 ways to remove the hot melt glue
1. Remove the thermofusible adhesive with alcohol
It is recommended to choose anhydrous medical alcohol, to deposit the medical alcohol on the hot melt adhesive or to use a small tempered cotton swab. In alcohol and applying it on the hot melt adhesive. Once the thermofusible adhesive hardened, it can be easily removed.
2, refined glue Fengyou
Put the oil from air on the hot melt adhesive repeatedly to leave the thermofusible adhesive dissolve slowly. This method will be slower, but it is respectful of the environment.
3, method of damping ice bags
that the hot melt glue is glued on clothes or tables and chairs, you can apply a small ice bag on it, wait A few minutes, then remove it gently with your nails.
4. Needle injection method
Pull the needle into anhydrous medical alcohol and injected it into the hot melt adhesive. This method not only saves alcohol, but also completely eliminate the thermofusive adhesive in the corner.
5. Method of frozen tamance
If it is a small article with thermofusible glue, put the article in the refrigerator to freeze, or take a glacon and place it on the top of The article, then it can be easily removed.
Instructions for the use of glue gun
1. Glue leakage problem
when the glue has just finished, there is an excess glue inside, and the pressure has not been released. It is normal that there is A small flight under the action of inertia.
2, Pour the
glue problem during the preheating period, the solid glue has not melted in the liquid state. At this point, pressing the trigger with force can cause an overflow of the glue.
3. Filling problem
When the glue stick is almost exhausted, simply insert a new glue stick from the stick stick sleeve and connect it with the glue stick. Origin to continue using it. The glue stick can be inserted into the second glue pistol after being completely inserted into the glue gun. The glue sticks that are not used for work can not be removed and left in the gun for next use.
4. Power-up problem
It is generally recommended to warm up for about 3 minutes and turn off the device when not in use.
Please allow a slight deviation in the measurement data and make sure it does not bother you before ordering.
High quality store for you!
Questions & answers
All you need to know about this product from our experts
No questions have been asked (yet). So you can get started as soon as you are ready!