Qcwwy Power Time Relay Switch with 16 Delay Modes for Safety and Energy Efficiency, Suitable for Incandescent Lamps, 1 Channel Output (with housing).

1. BETTER CONTROL: The relay switch can reduce energy consumption after a delay, and intelligent control will save energy and improve safety. 2. 16 Delay Modes: With 16 delay modes: 1 minute, 3 minutes, 5 minutes, 10 minutes, 15 minutes, 25 minutes, 30 minutes, 40 minutes, 50 minutes, 60 minutes, 90 minutes, 120 minutes, 180 minutes, 240 minutes, 300 minutes, and 480 minutes. 3. Wide Range of Uses: You can control incandescent lamps up to 1400W and 300W energy-saving lamps suitable for fans, motors, refrigerators, etc. 4. Good Design: The LED indicator is always on to show the working status; it flashes to indicate the end of the delay, making it very clear. 5. Easy to install: Also compact and in size, convenient installation can be completed quickly in minutes.

Specification: Item type: Relay switch Output current: 7A, maximum 10A Working power consumption: 43mA Supply voltage: AC 110-220V Maximum standby power consumption: 12mA Control channels: 1-channel output Working temperature: -25℃ ~ 85℃ Working humidity: 5% ~ 95% RH

Operating instructions: A. Module function: This module is a delay-stop module. When the set delay time expires, the power is cut off. B. Working status: The PWR LED will remain lit after power is activated and will continue to illuminate after the delay time expires. C. Instructions for Use: 1. Set the desired delay time and configure the field to disable it. 2. After verifying that the wiring is correct, power up the module. Once powered, the module will begin operating and the indicator light will remain on. After the set time, the module will shut off the power supply and the indicator light will flash. 3. If you need to disable the module before use, disconnect the main power supply directly from the module. 4. To begin the second half of the delay, power it up. D. Selecting the Delay Time: 1. Refer to the delay table to select the desired delay time. 2. Use the red plunger key according to the delay table. 3. After configuration, check the wiring and then the line.

Package list: 1 XRELAY switch

Note: When a new delay mode needs to be defined, it must be set to the disabled state to ensure the safety of personnel and prevent power operation.