Round Brushed Brass Thermostatic Dual Control Twin Head Shower Mixer + Fast Fit

This solid brass round thermostatic exposed shower mixer valve - brushed brass dual kit riser pack is a sleek and modern design and a cost effective showering solution. Includes a stylish ultra thin 8"" / 200mm round shower head with adjustable swivel joint.

This thermostatic shower mixer with bar valve allows you to halt or control the flow of your shower whilst the thermostatic control gives complete temperature performance, suitable for any modern bathroom.

The left handle on the bar shower controls the water on/off and the water flow and the right handle controls the temperature, with a range of 20-50 degress C. which also has a safety stop preset as a set temperature of 38 degrees C. for comfort and safety.

There is also a diverter on the bar valve to switch between both the outlets; shower head and shower handset.

The slider rail is adjustable to suit your preference and height of the riser rail can also be adjusted from 800 -1150 mm and also comes with a 360 degree adjustable bracket for the handheld shower, which you can also slide up and down the rail to suit your preference.

Includes Fast Fit Fitting Kit

Supplied with a 10 Year Guarantee for Peace of Mind

Key Features

8"" (200 mm) solid brass ultra thin round shower head with an adjustable swivel joint, so it can be tilted to adjust the spray and allow ease of use
Exceptional build quality and finish
Tarnish and corrosion resistant
Child friendly - features a built-in anti-scalding safety device, which makes it ideal for family bathrooms
Durable and solid brass construction
Matching handset with a Brushed Brass finish
Easy clean rubber nozzles on both overhead and handset
1.5m flexible stainless steel shower hose
Round thermostatic mixing valve of brass construction with built-in diverter and Brushed Brass finish (not cheap plastic valve)
The height of the riser rail is Adjustable (from 800 mm-1150 mm) and you can slide the hand held shower head up and down to a suitable height.
UK standard size fitting
Package contents: thermostatic mixer bar valve, riser rail, shower head, handset shower and 1.5m shower hose

Includes a fast fit fixing kit for bar valve showers aimed at easing the installation of bar shower valves.

Removes the need for in wall support battens. Reduced chance of in wall leakage as all joints are outside of the wall. Suitable for all UK manufactured bar valves.

Fitting Instructions:

First check the thermostatic mixer valve (TMV) you are fitting has inlets at approximately 150mm centres and it has 3/4\ thread fittings (Most showers do).

1. Fit inlet pipes in 15mm copper tube so the outlets are at 150mm centres using the template which is provided and the tube protrudes at 30mm +/1 2mm from the finished surface tile. The inlet pipes should be fitted to allow about 2mm adjustment in each direction with a hole through the tiles of approximately 20mm diameter.

2. Fit the wall plate over the copper tube and mark a suitable place to drill the holes. Drill the holes and fit the wall plugs then using the screw okate fit the screws to hold the wall plate lightly in the required position. The screw plate allows for some adjustment of the fittings to fit and level the mixer valve.

3. Fit the olive it should protrude by at least 4mm from the wall plate. Whilst holding the wall plate with a spanner (40mm) tighten up the chrome plated threaded adaptor with a 22mm spanner up to the adjustable screw plates so the olive seals on the 15mm tube.

4. Check the TMV fits to the wall plates and adjust for the level then tighten the screws. Fit the cover plates which will be provided with your thermostatic bar valve and attached the bar using the washers provided with the bar valve.