SEBS – Red Car Shock Absorbers, 2 Pieces/Set, Adhesive Buffer Springs, Automotive Maintenance Tool, Shock Springs (A)

Specification: Material: SEBS Type: A, B, C, D, E (optional) Color: Red Type Diameter Height Spring Adapter Thickness Spring Adapter Height Spring Adapter Diameter A 184 mm / 7.2 inches 82 mm / 3.2 inches 11-13.5 mm / 0.43-0.53 inches > 49 mm / 1.9 inches 170 mm / 6.7 inches B 160 mm / 6.3 inches 73 mm / 2.9 inches 11-13.5 mm / 0.43-0.53 inches > 38 mm / 1.5 inches 145 mm / 5.7 inches C 141 mm / 5.6 inches 53 mm / 2.1 inches 11-13 mm / 0.43-0.51 inches > 27 mm / 1.1 inches 128 mm / 5.0 inches D 124 mm / 4.9 inches 44 mm / 1.7 inches 10-13 mm / 0.39-0.51 inches > 21 mm / 0.8 inches 113 mm / 4.4 inches E122 mm / 4.8 inches 40 mm / 1.6 inches 9-12 mm / 0.35-0.47 inches > 18 mm / 0.7 inches 112 mm / 4.4 inches Installation Method: 1. It can be installed in a 4S shop. Before installation, stop the car on level ground and prepare adhesive, a jack (which is more convenient if it can be mounted on a stand), and soapy water (which can also be replaced with diluted detergent). 2. The body of the mounting part is lifted with a jack (or the entire vehicle is lifted with a chassis). The spring is stretched to facilitate installation. The shock absorber spring can be fully seen; there's no need to mount it too high. 3. Spray soapy water to clean the spring (mainly to remove sand stains), and spray soapy water to lubricate the shock absorber's adhesive (sufficient lubrication will make positioning and aligning the spring easier). After installation, thoroughly clean the area with soapy water to prevent the shock absorber spring from breaking, which is a safety component of automobiles and can cause injury. 4. Apply the damping adhesive.