[High Quality] The sill or water blocking layer is made of silicone rubber, which is safe, soft, high temperature resistant and wear resistant. No bad smells. Smooth surface easy to clean. Save your kitchen cleaning time.
Easy to remove, no glue left.
[Easy to Use] Cut the flexible silicone strip to the required length, remove the pre-adhesive tape and install the shower water dam in the marked position. The edge of the silicone water barrier should be sealed with glass glue. Let
dry and without contact with water for at least 24 hours.
[Sizes]The size of the dam: width: 1.6 cm (0.63 in); height: 3 cm (1.18 in). A variety of sizes are available, you can measure the approximate size required before placing an order to avoid shortage or waste.
[Good function] The shower threshold for the bathroom provides good protection, keeps water inside the shower enclosure, prevents water overflow, don't worry about water damage. water. It can be applied on flat tiles
and smooth, glass or ceramic, works great on the outside rim of the shower pan and shower base.
Waist:50cm/19in | Colour:White White
1 x water barrier
Length: length 50cm, white
Height: 3 cm (1.18 inches)
Width: 1.6 cm (0.63 inch)
1.Long and flexible design creates all kinds of shapes.
2.The shower barrier and retention system keep water inside the threshold.
3.Ideal for rimless showers and other areas where water needs to be contained.
How to use:
1. Wipe off water and dust on the floor.
2. Determine the position of the water retention strip and mark it with a marker on the floor.
3. Remove the adhesive and install the water barrier in the marked position.
4. Seal the rubber strip where the two ends of the water retaining strip are in contact with the wall.
5. Apply glue to both sides of the water cap and apply evenly.
6. Leave to dry and without contact with water for at least 24 hours.
1.Please allow 1-2cm error due to manual measurement.Please make sure you do not mind before you bid.