Self-adhesive fireplace insert gasket, heat-resistant braided gaskets for stoves and fireplaces (3mm x 10mm x 2m)

✅【Seal Size】 Thickness x Width x Length. This is the meaning of our style name numbers. Please select the braided sealing gasket based on these measurements. ✅【Easy to Use】 LANUCN gaskets are self-adhesive. They are covered with a layer of heat-resistant double-sided tape, making them easy to install without adding any other adhesives. Clean and dry the surface, peel off the protective film, stick it on, wait 12 hours, and you're done! ✅【Improved Durability + Airtight Performance】 Benefiting from fiberglass rope material and craftsmanship improvements, the LANUCN stove glass gasket is tested up to 600°C, heat-resistant and smoke-free. ✅【Wide Application】 Almost all smokers and ovens can use it, such as cookers, ovens, fireplaces, grills, smokers, tube stoves, chimneys, etc. ✅【Important】 1. The temperature of direct flame is well above 600°C, so do not let it touch the flame directly or exceed 600°C. 2. When used on a vertical surface, a component to secure the sealing rope is required; otherwise, additional sealant must be added for reinforcement. Product Description LANUCN Fireplace Insert Seal: After prolonged use of the fireplace, the chimney door seal will likely develop smoke leakage. Here is our quick and easy solution. Features: Improved craftsmanship, no smoke leakage. Self-adhesive, easy to use. Extreme durability up to 600℃. Long-lasting service. Scope of application: Almost all fireplaces and ovens can use it, such as cookers, ovens, fireplaces, grills, wood stoves, flue pipes, chimneys, etc. Instructions: 1. Clean and dry the surface. 2. Peel off the protective film. 3. Stick it in the correct position and wait 12 hours. 4. That's it! Important Tips: 1. The temperature of direct fire is well above 600°C, so do not allow it to come into direct contact with fire or to exceed 600°C. 2. When used on a vertical facade, a component to secure the sealing rope is required; otherwise, additional joint adhesive must be added for reinforcement.