Small European standard fan heater with thermostat, timer and remote control

Never fear the cold again thanks to the rapid production of warm air. POWERFUL: A powerful ceramic heating element quickly produces heat at the touch of a button. Temperature levels are preset and maintained constant by the thermostat, ideal for cold winter days and as a supplementary heater. Generates heat on demand. Easy to use: Thanks to its plug-and-play technology, this heater works in any room and with any outlet. Intuitive temperature and timer controls with a central LCD display. The included remote control is ideal for using the power strip in hard-to-reach places. Specifications: Power supply: 220-240V AC, 50/60Hz, power: 500W. Dimensions: 19 x 11.5 x 12.5 cm. When switched on, the heater and fan operate by default for 12 hours without any button being pressed. Press the "Time" button to access the timer setting: "Old" = press the "+" and "-" buttons to adjust the duration; "New" = press the "Time" button to adjust the duration. Then press the "Time" button again to return to the temperature setting. The initial temperature display is 20°C. To adjust the temperature, use the up and down buttons (from 15 to 32°C). In timer mode, set the duration from 1 to 12 hours. Press the "Fan" button to select between high speed (HH) and low speed (LL). The heater switches off automatically when the programmed temperature is reached. The fan continues to run for 60 seconds, then switches off. The display shows "OF". If the temperature is 1 degree lower than the set temperature, the heater switches back on. When the timer expires (12 hours by default), the heater stops, the fan continues to run for 60 seconds, then stops, and the display shows "OF". Once the cycle is complete, press any button to restart it (12 hours by default). If the "natural breeze" function is available, press and hold the "+ -" button for three seconds to activate it; "CC" will be displayed. Press and hold the "+ -" button for three seconds to deactivate the function; the "natural breeze" function pre-start setting will be displayed.