Solenoid electric 4V210-08, 2 positions normally, 5 channels, drain of air compressed for workshop automatic, DC 24V

Features:

1. Save of the energy : a coil of brake to foot in copper red is used, energy saving, low power consumption of energy, not easy to heat.

2. High quality : body of valve in aluminum alloy wear-resistant, interface of wall indoor smooth without burrs, molding in sand end of surface.

3. With spring : spring in stainless steel high fatigue, not easy to the deformation permanente caused by the damage of buttons mcaniques.

4. Large application : it is used in the industry of equipment medical, the industry of the transformation of food, the industry of robots, the industry of applications chemical, etc.

5. Good performance : beautiful work, performance upper. Strong hardness, resistance to the corrosion, resistance to the impacts, long service life.

Specifications:

Item type : Solenoid electric

Material : Aluminum alloy + stainless steel + copper red

Model : 4V210-08 communication

Range of voltage : AC : 15 %, DC : ±10 %

Opening of the coil : Approx. 8 mm/0,3 inches

Middle of work : Air

Diameter of the hose : Input, output : G1/4, Exhaust : G1/8

Area of section transversale effective : 16,0 mm²

Number of positions : two on five Channels

Range of pressure : 0,15 ~ 0,8 Mpa

Temperature of operation : -20 ~ 70 ℃

Frequency of operation maximum : 5 times/second

Consumption of energy : 4,5 GOES

Rating of sealing : IP65

Application : industry of equipment medical, industry of transformation of food, industry of robots, industry of applications chemical, industry textile, workshop of automation

List of package:

1 solenoid electric.

Note:

1, the installation of the solenoid must make attention to the body of the fleche which must be coherent with the flow of the the. Not install in of areas exposed to drops of water or to splashes directly. the solenoid must be installed vertically toward the high.

2, the solenoid must ensure that the voltage of supply is included between 15 % and 10 % of the range of fluctuation of voltage rated in operation normal.

3. After the installation of the solenoid, it not must y have no pressure differential reverse in the pipe. And it faut électrifier several times, in order that the temperature powerful be formellement used.

4, the solenoid must be carefully rincant before the installation. The bracket must be exempt of impurities. The filter is installed front the valve.

5, in case of failure or of cleaning of the solenoid, in order to ensure that the system continue of operate, must be installed a device of derivation.6, please note that the new type and the old type of this product will sent to the at, and ensure that this not you will not before of order.