Spraying system, 110-240V 16-nozzle misting cooling system Fine atomization for greenhouse factory.

1. With fine atomizing nozzles, a large filter surface area, good atomization effect, and energy and water savings. 2. Depending on different usage scenarios and effect requirements, the appropriate opening size can be selected to operate the misting system. 3. This nozzle can fully utilize tap water pressure for atomization, and the effect will be better when used with a high-pressure water pump. 4. The low-pressure spraying system can be used for landscaping, cooling, air humidification, dust reduction, deodorization, and air purification. 5. Suitable for cold storage, greenhouses, livestock farming, flower nursery cultivation, fruit and vegetable freshness, antistatic applications, fog prevention, humidification, and cooling. 6. Suitable for humidification and cooling in textile factories, electronics factories, paper mills, printing works, automobile factories, wood processing plants, power plants, steel mills, breweries, and food industries. Specification: Condition: Brand new Item Type: Garden Cooling System. Material: PE Diaphragm Pump: Voltage: DC12V Power: 60W Pressure: 0.8 MPa Water Flow: 5L/Min Weight: Approx. 1552g / 54.7oz Total Hose Length: Approx. 12m / 39.4ft Application: 1. Wetting and rust removal 2. Air humidification 3. Chemical treatment 4. Chemical spraying 5. Liquid spraying 6. Leaf humidification 7. Tablet coating 8. Combustion gas evaporative cooling 9. Cleaning 10. Component cooling 11. Fruit wax spraying 12. Glazing tiles 13. Factory humidification 14. Salt spray testing 15. Artificial fog 16. Humidification in other locations Installation steps: 1. It is recommended to install the atomizing system at a height of 2.5m to 3m. 2. Open the tap to flush the system for 1 minute to remove impurities. 3. Screw the spray nozzle onto the T-fitting, except for the end fitting. 4. Open the tap to flush the system for 2 minutes to ensure it is completely clean. 5. Turn off the water and attach the last nozzle to the seal, using the end cap. 6. Secure the spray hose with the provided cable tie. 7. Connect one end of the supplied water supply hose to the pump's water inlet and place the other end in the bucket. 8. Connect the water outlet hose to the pump's water outlet. The arrows on the pump cover indicate the direction of the water outlet. 9. Turn on the water pump until the sprayer is working and enjoy the cooling spray system. 10. When the spray system is not in use for an extended period, close the nozzle and keep it dry and clean. Package List: 1 x 12V Diaphragm Pump, 1 x Home Power Adapter, 1 x Mounting Accessory (Inlet Hose + Filter + Anti-Float Device), 1 x 90 Degree Pump Inlet Elbow, 1 x Handle Clamp, 1 x G1/4 Spray Hose (12m/39.4ft total), 16 x Copper Sprayers, 16 x Sprayer Bases, 1 x Hose End Cap, 40 x Hose Loops, 40 x Hose Straps, 2 x Sealing Tape, 1 x G1/2 to G1/4 Adapter. Note: 1. Please allow 0-1 inch error due to manual measurement. Thank you for your understanding. 2. Monitors are not calibrated the same, item color displayed in photos may be showing slightly different from the real object. Please take the real one as standard.