T316 Stainless Steel Square bolt (C bolt) complete with 1 full nut and 1 half nut on each leg
To Suit 30*30 RHS (Rectangular hollow Section)
Ideally suited for use with standard rectangular hollow section, but of course will have many uses
These 1124 series are for holding just one RHS onto a supporting material not exceeding thickness 2*A
Please refer to diagram for details (all measurements in mm):
RHS : 30*30
A = 8 mm
B = 31 mm
C = 54 mm
D = 24 mm
Centers = 39 mm
See 1125 series which are extended leg for thickness of supporting material greater than 2*A
Our manufacturing tolerances are + / - 1 mm)
We use roll threading so the diameter of the bar is usually less than the thread size. Please ask if unsure