Static Window Film, Self-Adhesive Window Film, Privacy Window Film, Frosted Window Film for Kitchen, Office, Bathroom, 44.5 x 200cm

【Privacy Protection】 This privacy window film provides privacy while allowing light to enter, letting you enjoy daylight while avoiding prying eyes. Ideal for the kitchen, living room, bedroom, and office. It's an economical alternative to expensive frosted glass.

【Classic and Aesthetic Design】 The glass's appearance is noble and elegant, enhancing your taste and home decor.

Simple design, a practical film to ensure privacy.

【No Adhesive】 The glue-free design reduces chemical release, leaves no residue after removal, and is completely reusable.

【Easy Installation】 Cut the window stickers to fit your window size. Spray soapy water on the glass during installation, and press out any bubbles with a credit card or squeegee.

【UV Protection and Energy Saving】 This window film reduces heat and glare, blocking 90% of UV rays. It minimizes furniture fading caused by the sun. Advantages of this Window Film:

1. Privacy window film provides privacy while allowing light to enter.

2. Our window film is capable of blocking 96% of UV rays.

3. The static cling of the film to the glass is strong, so there will be no glue residue after removal and the film is completely reusable.

4. The glue-free design reduces the release of chemicals.

Installation Steps:

1. Remove the film backing and prevent the window film from falling. The clear adhesive film behind the glass film must be removed before installation.

2. Measure the window film, then cut it to size.

3. Clean the glass surfaces.

4. Thoroughly wet the pre-cleaned windows with soapy water.

5. Apply to a wet window and smooth with a credit card or squeegee (squeegee NOT INCLUDED).

6. And finish trimming the excess with a utility knife around the edges of the windows.

Buyer Comment and Buyer Display

Simple, quick, and very effective solution for sealing a shower enclosure. Plus, it's stylish! It cuts through shapes but lets in enough light. A pleasure to install.

Customer Advice:

1. If the window film won't stick and falls off, it might be because the clear backing film hasn't been removed, or not enough soapy water was sprayed on the window. Remove the clear backing film and spray more soapy water.

2. Remove water and air bubbles: Spray water on the film, press from top to bottom, and center it on both sides. To prevent water from seeping back into the film, use a cloth to wipe away excess water.

3. The film's adhesive effect may not be very effective in winter. Solution: Before applying, use a hairdryer to make it pliable (heat resistance below 70 degrees Celsius).