Trigger Cycle Delay Timer Switching Module with LED Display for DC Motors, LED Strip Lights

Specifications:

Voltage: DC 5V ~ 36V. Trigger signal source: High-voltage trigger (3.0V ~ 24V). The signal ground and system ground are not connected to a common ground to improve the system's anti-interference capability (you can also connect them to a common ground). Output capacity: DC 5V ~ 36V, at room temperature, the continuous current is 15A, power 400W. With improved heat dissipation, the current can reach 30A.

Standby current: 20 mA Operating current: 50 mA Operating temperature: -40 ℃ ~ 85 ℃ Clock range (delay): 0.1 seconds to 999 minutes Size: 60 * 34 * 12 mm / 2.36 * 1.33 * 0.47 in

Instructions: Operating mode: P1: Trigger signal, the relay is activated during the OP time, then disconnected; during the OP time, as follows: P1.1: The signal is triggered again, invalid P1.2: The signal is triggered again, synchronization is reset P1.3: The signal is triggered, reset again, reconnect and stop the timing; P-2: Trigger signal, the relay turns off after the time, the relay is activated, then disconnected after the timing P3. 1: Trigger signal, the relay is activated after the OP time, the relay deactivates during the CL time, then the operating cycles continue; if the trigger signal is present again during the cycle, the relay deactivates, stopping the number of cycles (LOP); the number of cycles can be set. P3.2: Without triggering the signal after power-up, the relay is activated during the "OP" time, the relay deactivates during the "CL" time, then the operating cycles continue; the number of cycle times ("LOP") can be set. P-4: Signal hold function. If there is a signal of