V4 Mini FSESC4.12 50A High-Current ESC with Anodised Aluminium, Single-Drive Electronic Speed Control

Features:

1. Small and exquisite, widely used, can be installed in various products, smaller in size and lighter, suitable for scooters, robots, and other products.
2. Flipsky ESC is based on the open-source VESC project and is compatible with VESC software.
3. Flipsky ESC is a highly customizable electronic speed controller designed for DIY electric skateboard conversions.
4. Flipsky ESC allows you to use a sensorless motor for smooth starting, whereas traditional RC ESCs may not be able to start. It also provides a powerful, reliable, and progressive electric brake.
5. The maximum continuous current can reach 50 A, with temperature protection and current limit protection, supporting multiple control modes.

Specifications:

Condition: 100% Brand New
Item Type: Electronic Speed ​​Control
Color: As Pictures Shown
Material: PCB Board + Aviation Aluminum Alloy Heat Sink + Thermal Silica Gel + Mos Tube
Model: V4. 12 Standard ESC Configuration
Hardware: V4.12
EPRM: 60000
Firmware: V3.40 (keep the latest firmware version)
PCB: 4 layers
PCB Size: approx. 40 x 60 mm / 1.57 x 2.36 inches
Current: Continuous 50 A / Peak 240 A, depending on installation and ambient temperature around the device
Voltage: 8-60 V (can be used for 3S to 12S LiPo batteries, peak voltage should not exceed 60 V!)
Recommended 10S battery (not included)
BEC: 5 V at 1.5 A
BEC Type: Supports internal driver
Time: Software calibration
Motor Control Interface: PPM Signal (RC servo), Analog, UART, I2C
USB or CAN bus. />Cutoff voltage: programmable
Frequency: PWM input
Regulator: no
Weight: approx. 80 g / 0.18 lb
Fsesc4.12 Size: approx. 110x40x20mm / 4.3 x 1.6 x 0.8 inches
Programming Card: No
Reverse: Yes
Motor Wire: 12AWG
Power Cord: 12AWG

Package List:

1 x Electronic Speed ​​Controller

1 x USB Cable

1 x VESC Sensor Wire

1 x Manual

Note:

By default, the LED button has been inserted into the switch at the factory. Please do not turn on the switch without the LED button connected.