Valve core extractor/installer, SAE 1/4" and 5/16" brass disconnect valve, dual size to prevent refrigerant leaks for R12, R22, and R410A.

General Description

SAE 1/4" and 5/16" brass valve core removal and installation tool, designed to prevent refrigerant leaks in R12, R22, and R410A systems. This tool allows for quick and easy replacement of leaking coils, while its solid brass construction ensures durability. It is equipped with a metal knob with anti-slip knurling for extended use.

Technical Specifications

• Material: Solid Brass
• Total Weight: 200 g
• SAE Female Thread: 1/4 and 5/16
• SAE Male Thread: 1/4
• Color: Yellow
• Package Contents: 1 Coil Remover Installer, 1 Coil Remover, 10 5V1 Valve Cores

Installation

• Close the coil wrench valve and disconnect the internal connection from the air conditioner before removing the coil.
• Remove the dead center on the valve stem and close the valve on the tool.
• Adjust the connection between the tool and the air conditioner interface, then tighten the valve on the air conditioner.
• Make sure the tool is properly connected to the air conditioner valve, then open the valve on the tool.
• Push the valve stem into the A/C valve and gently turn the rear knob of the extractor.
• After removing the valve core, remove the valve stem, close the valve on the disassembler, loosen the screw at the end of the tool, and remove the valve core.

Use

Used to remove and install coils in live systems, this tool allows control of the core without the need to shut off or release the refrigerant, saving valuable time during service calls.

Other Information

• Note: Photo lighting and different displays may cause a slight difference between the color of the item in the picture and the actual color.
• Measurement allowable error is +/- 1 to 3 cm.