Waterproof 12/24V Wind Turbine Charge Controller – 300W/600W Power – IP67 Protection – Automatic Battery Control

1. 100% brand new and high quality.

2. This controller automatically charges the wind turbine to charge the battery.

3. When the battery is fully charged, the fan is braked by the automatic control of the internal circuit. When the battery voltage drops to the recovery voltage, the fan resumes charging the battery, thus protecting both the fan and the battery.

4. The rectifier and braking circuit of the controller adopt an integrated module design.

5. Fully waterproof, fully sealed, and fully sealed, with a protection level exceeding IP67.

Specification:

Features:

1. 100% brand new and high quality.

This controller automatically charges the wind turbine to charge the battery.

2. When the battery is fully charged, the fan is automatically braked by the automatic control of the internal circuit.

When the battery voltage drops to the recovery voltage, the fan resumes charging the battery, thus protecting both the fan and the battery.

3. The rectifier and braking circuit of the controller adopts an integrated module design.

4. Fully waterproof, fully sealed, and fully sealed protection, with a protection level exceeding IP67.

Specification: Condition: 100% Brand New

Model: FW12/24

Battery Nominal Voltage: 12/24V

Wind Turbine Nominal Power: 300W/600W

Brake Start Voltage (Factory Value): 14.4V/28.8V

Brake Recovery Voltage (Factory Value): 13.2V/26.4V

Display Mode: LED (Light Emitting Diode Display)

Operating Temperature and Humidity Range: -35℃-+75℃

Quiescent Current: ≤15 mA Protection Level: IP67

Weight: approx. 255g / 9.0oz

Size: approx. 100 * 87 * 28 mm / 3.9 * 3.4 * 1.1 inches Wiring: 1. Connect the positive and negative terminals of the battery to the positive (red) and negative (black) terminals of the battery.

2. Connect the three-phase output voltage of the wind turbine to the three-phase input terminal (green line) of the controller fan.

Package List: 1 * Wind Turbine Controller

Note: 1. Check that the output voltage of the wind turbine matches the rated voltage of the battery.

2. Wiring Sequence: First connect the positive and negative terminals of the battery, then connect the three-phase voltage output of the fan.

Please connect the battery and wind turbine to the controller strictly according to the instructions. If the polarity is reversed or if the wrong position is used, the system will malfunction and may even completely damage the controller. 3. Please note that the new and old types of this product will be sent randomly, and please ensure this is acceptable to you before ordering.