WDU6008 DC-DC 90W 4A Adjustable CC CV Step Up Boost Power Supply Module LCD Dual Display

1、Non-isolation boost module, can adjust the voltage and current, can charge the battery.

2、LCD dual display of real-time voltage and current.

3、With input reverse polarity protection and output anti backflow function.

4、The module outputs constant current and voltage to stably power electronic device.

5、11-60V output voltage, output current up to 8A.Item Type: Step Up Power Supply Module

Input Voltage: DC 10V-32V

Output Voltage: DC 11V-60V continuously adjustable (recommend not to over 55V)

Output Current: Max 8A (More than 4A, please enhance heat dissipation)

Output Power: Max 90W in natural cooling, Max 150W in enhanced heat dissipation

Constant Output Current: 0.3-8A

Working Temperature:-40°C ~ +85°C (When ambient temperature is too high. please enhance heat dissipation)

Working Frequency: 150KHz

Conversion Efficiency: Up to 95% (related to input and output voltage, current, voltage difference)

Short Circuit Protection: None

Input Reverse Polarity Protection: Yes

Output Indicator: With charging indicator, charging - yellow, fully charged - blue

Output Anti Backflow: Yes

Module Size: 80x53x35cm / 31.5x20.87x13.78in

Calibration:

This module has calibration function, don't worry about the problem of inaccurate measurements. If you found inaccurate measurement, can use the following method of calibration. Just calibrate once for the first time use!

Voltage Calibration: when power off status, keep press the "set" key. power on, enter the voltage calibration mode. then the LCD screen starts flashing. release the "set" key, press the "Set" button to increase, press the "ENT" button to reduction, until calibrated to the correct input voltage. For example: the input voltage is 12.65V, then the voltage was adjusted to 12.65V. then automatically saved after 2 seconds, power off,calibration is complete!

Setting Instruction:

Setting key to set the display node, it have three types:

1. F-0 mode: Display output voltage

2. F-1 mode: Display input voltage

3. F-2 mode: Alternately display input or output voltage

Tip: Press the "SET" button to cycle through the three display modes, the corresponding indicator will be on or off, then press the "ENT" button to save and exit. if separate press 'ENT" button to switch backlit LCD screen.

Using Instructions:

Adjusting Voltage: under no-load conditions, adjust the "constant voltage potentiometer ADJ-V", so that the output voltage reaches the value you want

Adjustment Current: connected to the load, adjust the "constant current potentiometer ADJ-I", so that the output current reaches the current value you want (the factory default is more than 2A, if you want to adjust the current value is small. more counter-clockwise tune laps will change), if you do not need constant current,it don't need adjustment

Indicator color change instruction: Charge turn lamp current factory default is 0.1 times the charging current:battery during charging. the current is gradually reduced, gradually turned from the constant current charging to constant voltage charging, if the charging current setting is IA, then when the charge current is less than 0.1A. the charging yellow indicator light off, full of blue indicator lights up and the battery is fully charged..w-e-text table td,.w-e-text table th,.wang-edit-text table td, .wang-edit-text table th{border: .5pt solid #000;};.w-e-text table,.wang-edit-text table{border: 1px solid #000 !important;}

1 x Module1 Bag x Holder and Screws