Wireless Motion Detection Alarm for Garden Shed - Home Security - Battery Powered - Suitable for Summer Garages, Caravans - With 2 x Remote Controls

Detection range: distance 4-5 meters, angle 100 degrees

Operating voltage: AC 220 V (self-equipped adapter), DC 6 V (4 AA batteries can be installed, battery is not included!) Remote control with button battery

Alarm sound level: 105 dB (measured at 30 cm)

Product features:

1. Infrared detection alarm

2. Infrared remote control, equipped with two remote controls

Installation requirements:

1. Since the remote control infrared warning device has the highest infrared detection sensitivity when the human body moves sideways to the lens, but has low sensitivity for longitudinal movement, it is worth paying attention to the angle and height of the horizontal plane of the detector when installing, which has a great impact on the protection area.

2. When installing, the infrared warning device should be kept away from hot and cold sources, such as hot and cold air outlets, air conditioning outlets, electric heaters, air coolers, etc., and should not be directly facing the door.

3. The remote-controlled infrared warning device must be able to see directly into the protected area without any obstacles.

4. The infrared warning device of the remote control should be at an angle of 10 to 30 degrees with the wall. At this time, the detection distance is the farthest. During actual installation, adjust the installation angle according to the situation.

Installation method:

1. Secure the gimbal approximately 2 meters from the ground.

2. Open the battery cover and insert 4 AA batteries according to the markings inside the battery case.

3. Fix the remote control infrared warning device on the gimbal and rotate the infrared warning device to meet the installation requirements and detection needs.

How to use:

1. Install the battery. Press the remote once, the machine will beep and the green light will turn on. Indicates that the alarm is ready to enter operating state.

2. The remote infrared warning device has a 15-second sleep delay when the green light is on. If the alarm signal is not detected within 15 seconds, you must leave the detection area of ​​the electronic dog within these 15 seconds.

3. If someone enters the detection area of ​​the infrared warning device after 15 seconds, the red light will flash for 5 seconds. During this 5 second delay, the owner can use the remote control to deactivate the alarm. After 5 seconds, if no signal from the remote control is received, a loud alarm will sound for 30 seconds and the alarm volume is 105 DB. 15 seconds after the alarm goes off, if someone touches the remote infrared alarm again, the alarm will sound again and the cycle will start again.

4. When the remote control's infrared alarm triggers an alarm, you can use the remote control to turn off the detection circuit and end the alarm.

-Contact our customer service in case you need further assistance