Wireless PIR Infrared Motion Sensor Home Security Motion Detector Alarm. Battery Operated Alert System Kit for Indoor Residence Driveway Garage Warehouse

Package Included: 2/4 x Infrared Sensor Alarm, 4/8 x Infrared Remote Control, 2/4 x Mounting Brackets. Features:

● Using advanced infrared detection technology, reliable performance.

● The infrared sensor automatically detects human body signals and emits an alarm.

● Super loud 105dB alarm.

●

Infrared sensor detection range: 110°, 0-5M

● Infrared remote control, originally equipped with two remote controls.

● The induction doorbell is easy to install (1 set on a desk or hung on the wall) and can be placed in doors, windows, and driveways.

● Uses 4 AA 1.5V batteries (not included). Specifications:

Detection range: 4-5 meters.

Operating Voltage: DC 6V (4 AA batteries can be installed inside) Remote Control: Initially equipped with two infrared remote controls

Remote Control Distance: 4-5 meters Alarm Sound Level: 105 dB (decibels) measured at 30cm Installation Requirements:

◆ Because the infrared remote control warning device has the highest infrared detection sensitivity when the human body moves laterally relative to the lens, but the sensitivity to longitudinal movement is poor, pay attention to the angle and height of the detector's horizontal plane during installation, as this significantly impacts the protection area.

◆ During installation, avoid placing the infrared warning device near sources of cold and heat, such as hot and cold air vents, air conditioning outlets, electric heaters, and air coolers.

◆ The remote infrared warning device must be able to directly view the protected area without obstructions.

◆ The remote infrared warning device should be at an angle of 10 to 30 degrees to the wall. At this angle, the detection range is at its maximum. Adjust the installation angle according to the actual installation. Installation Method: 1. Fix the universal base approximately 2 meters from the ground. 2. Open the battery cover and install 4 AAA batteries according to the markings inside the battery compartment. 3. Fix the remote control infrared warning device to the universal base and rotate the infrared warning device to meet the installation requirements and detection needs. Instructions: 1. Install the battery. Press the remote control once. The device will beep and the green indicator light will illuminate. This indicates that the alarm is ready to operate. 2. The remote infrared warning device has a 15-second delay when the green indicator light is on. If no alarm signal is detected within 15 seconds, you must leave the electronic dog's detection zone within these 15 seconds. 3. If someone enters the infrared warning device's detection zone after 15 seconds, the red indicator light will flash for 5 seconds. During this 5-second delay, the owner can use the remote control to deactivate the alarm. After 5 seconds, if there is no signal from the remote control, a loud alarm sound will be emitted for 30 seconds at a volume of 105 dB. 15 seconds after the alarm sound ends, if someone touches the remote infrared alarm again, it will sound again, repeating the cycle. 4. When the remote infrared warning device triggers an alarm, you can use the remote control to close the detection circuit and stop the alarm.