XHW3005 Humidity Hygrostat Sensor Digital Hygrometer Switch Controller 0 to 99% R(12V)

Specification: Model: XH-W3005 Weight: 68g/2.4oz Input Voltage: 12V Humidity Range: 00% to 99% RH Humidity Control Accuracy: 0.1% RH Load Power: 120W Output Type: Direct Output Mounting Hole Spacing: 73mm/2.9in Size: 60*45*31mm/2.4*1.8*1.2in Operating Instructions: Thermostat connected to the circuit, connected to the power supply, the tube The digital display indicates the starting temperature of the current humidity setting. Press the "up" button to display the starting temperature, press and hold the "up" button for approximately 3 seconds, and the starting humidity level will flash. This can be adjusted using the up and down buttons. To set the stopping humidity: Press the "down" button to display the humidity. To stop, press and hold the "down" button for approximately 3 seconds to stop the digital humidity display flashing. The humidity level can be adjusted using the up and down buttons. To restore factory settings: With the power on, press and hold the up and down buttons simultaneously. The digital display will show 888 and then automatically switch to the humidity detection value, thus restoring the factory settings. Package List: 1 x Digital Humidity Controller Note: The W3005 is a direct output; therefore, please do not turn it on if the output end is not properly connected or is disconnected, as this could cause unnecessary problems due to a two-stage contact spark and careless wire contact.