0-100% Analog PWM Voltage Converter, 0-10V Digital Signal Conversion Module with Housing

Features: 1. SIGNAL CONVERSION: Converts a 24V input PWM 0-100% digital signal into a 0-10V output analog voltage signal. 2. STABLE CONNECTION: The power supply has reverse polarity protection, ensuring safe and stable operation. 3. APPLICATION: Widely used for switching signal interfaces in PLCs, single-chip microcomputers, and other industrial control boards. 4. SCRATCH-RESISTANT ABS: Made of excellent ABS material, offering impact resistance, scratch resistance, and environmental friendliness. STABLE AND DURABLE: The PWM voltage converter features a stable structure, excellent performance, and a long lifespan. Specifications: Item Type: PWM Voltage Converter Material: ABS Input: 0-100% 24V PWM Signal Output: 0-10V Conversion Method: Analog to Digital How to Use: After powering on, when there is no input signal, the output is 0V, and there is an input before the output. When powering on for the first time, you can perform calibration and debugging: find a signal with a 50% duty cycle and connect it to Din-, Din+, and the amplitude should be 24V. When the frequency is 1 kHz - 3 kHz, use a multimeter to measure the voltage across both the AO and GND ports. Currently, the meter reads approximately 5.4V. Adjust the potentiometer on the board to set the multimeter display to 5.40V. This calibrates your pulse signal to match this module. The resolution of this module is 0.1V. The output current capacity is 10mA. If the relationship between the duty cycle percentage and the voltage is inverse, you can check (or verify) the pin to set the PWM output in the For Mach3 software and click the corresponding pin's checkbox to enable and disable the pin. Port wiring: 1. DIN +: The PWM signal input is positive. (For a common cathode connection, connect the PWM signal here. For a common anode connection, connect the 5V or 24V signal terminal here.) 2. DIN -: The PWM signal input is negative. (When the common cathode is connected, connect the GND of the signal terminal here. When the common anode is connected, connect the PWM signal here.) 3. 15-30VDC: Positive terminal of the power input. 4. GND: Power supply ground wire. 5. GND: Signal ground wire. It is connected to the GND port of the power supply ground wire. 6. AO: Analog voltage (0-10V or 0-5V) output port. Package list: 1 x PWM voltage converter. Note: Match the appropriate model before use.