100A MPPT Solar Charge Controller 12V 24V 36V 48V LCD Display Battery Smart Regulator Max 100V Dual USB Input

General description

The high quality MPPT + PWM solar controller is useful for optimizing the energy efficiency of your solar system. Although it is not a 100% MPPT, its effectiveness is impressive, at just 99.5%. It automatically reconnects the voltages of 12V, 24V, 36V and 48V and has a double USB 5V charging port. V, 36 V, 48 V

• Nominal current: 100 A
• Maximal PV voltage: 100 V
• Maximal solar input (Voc): 15-25 V (12 V batteries) ; 30-50 V (24 V batteries); 45-75 V (36 V batteries); 60-100 V (48 V batteries)
• Maximum photovoltaic power: 1,200 W (12 V batteries) ; 2 400 W (24 V batteries) ; 3,600 W (36 V batteries); 4 800 W (48 V batteries)

Compatibility and accessories

Compatible with the charge of the following batteries:

• Seal
• GEL
• Flooded
• LifePO4

Installation

See the four instructions to ensure an installation correct and safe. Make sure that the system is currently under tension before starting the installation.

Using

To use the control, follow these steps:

• Do not allow the battery to be discharged.
• Light control mode: the control starts if unload after 10 minutes of night and stop after 10 minutes of day.
• Mode to control the light and delay: the discharge begins after 10 minutes at twilight and it will stop if you have a full charge.
• Mode de contrôle général : la discharge is maintained without interruption.
• Manual control mode: use the '▼' button to verify the charging status.
• Synchronization control mode: active or deactivated to regulate the charging.
• Test mode: similar to the control modes d'éclairage, mais avec l'élai réduit.
• Low voltage protection: the controller is disconnected in case of too low voltage.

Additional information

The controller is equipped with a multifunction LCD screen with backlight, displaying the clock and allowing access to 7 modes different functions.