3-in-1 Digital Oscilloscope, 3.2-inch IPS Display, 250MSa/s Multimeter

Features:

1. 3 in 1 Design with IPS Screen: This product ingeniously integrates the functions of digital oscilloscope, multimeter and signal generator in one device. 3.2 inch clear definition IPS screen, high sensitivity full display, channel 2 waveforms can be set to green/cyan/purple.
2. Signal generator: Built-in waveform signal generator, it can produce sine wave, square wave, triangle wave, etc. The voltage amplitude is 2.5V, the frequency is adjustable from 0 to 2 MHz, and the square wave duty cycle is adjustable from 1% to 99%.
3. High Precision Multimeter: Built-in True RMS multimeter, which supports quick software calibration. With DC/AC voltage, DC/AC current, capacitance, diode and continuity test.When measuring low voltage/continuity, the oscilloscope and multimeter functions can be used simultaneously (small window in the upper right corner).
4. Digital Oscilloscope Function: Dual channel oscilloscope function, with 120MHz bandwidth and 250MSa/s sampling rate. With trigger function (automatic, single, normal). Supports sensitivity and time base adjustment, automatic mode adjustment, 2-channel waveform analysis, cursor measurement, reference waveforms, FFT spectrum, reference waveforms, waveform recording and viewing.
5. Sensitivity and Time Base: The oscilloscope will automatically detect the signal and adjust the ranges. Supports manual waveform adjustment vertically and horizontally.Vertical sensitivity indicates the voltage in the vertical direction and is adjusted using the mV and V buttons to accommodate different voltages.Time base represents time in the horizontal direction.It is adjusted using the S and NS buttons to accommodate different frequencies.In standby mode, the user can move the waveform left and right.
6.Two automatic adjustment modes: supports one-button automatic and fully automatic modes. No complicated operation; you can quickly detect and display the waveform.In fully automatic mode, no keystrokes are required, and continuous automation is performed.
7. High bandwidth and sampling rate: The real-time sampling rate is 250 MSa/s, and the dual-channel bandwidth is halved to 60 MHz.
8.Dual Channel: With dual channel mode, which can measure and display two signal waveforms at the same time for waveform comparison and analysis.
9. XY Mode for Cursor Measurement: XY mode is imaging formed by combining the waveforms of two channels and is commonly used to display the phase difference or frequency relationship between two signals. Supports X cursor and Y cursor measurement. The horizontal cursor can be used, for example, to measure the time interval between two pulses. The vertical slider can be used to measure voltage and voltage difference at any two locations.
10. FFT Spectrum: FFT (Fast Fourier Transform) is an algorithm that transforms waveforms in the time domain into the frequency domain, which can be used to analyze the frequency component of waveforms. Linear and logarithmic displays are supported.Note: FFT can only display spectrograms; frequency measurement is not supported.
11.Reference Waveform: Supports reference waveform locking, statically displaying the current waveform on the screen, while dynamic waveforms continue to update normally.Can be used for reference and comparison between multiple waveforms.
12.Save/Display Waveform: Save the screen waveform with a single click. Go to the image navigation page, click the thumbnail for full-screen viewing, and delete unwanted waveform graphs at will.
13. Safer design: Uses an isolation transformer and an isolation optocoupler chip to isolate the multimeter from the oscilloscope, so you don't have to worry about common ground wiring.(When measuring high voltage, the multimeter and oscilloscope cannot be used simultaneously.)
14.