4-channel remote control for gates and garage doors – 433.92 MHz, compatible with Ditec GOL4/BIXLG4/BIXLP2/BIXLS2, 2-pack

Frequency: 433.92 MHz, remote control compatible with Ditec GOL4, Ditec BIXLG4, Ditec BIXLP2, and BIXLS2. The remote control comes with batteries and is ready to use immediately. Frequency: 433.92 MHz, transmission range: 50–100 meters, pairing required before use. 4 buttons to control up to 4 garage doors. Code: Rolling code replacement for increased security. Batteries included for immediate use; a better replacement. Pairing required before use. Material: High-quality, wear-resistant ABS. The buttons are user-friendly, and the smooth design ensures good handling, light weight, and high portability. 24-HOUR SERVICE: The product is shipped after manual inspection to guarantee a high-quality product. Should any problems arise after purchasing the remote control (pairing/frequency/model), please contact us. Frequency: 433.92 MHz. This remote control is compatible with Ditec GOL4, Ditec BIXLG4, Ditec BIXLP2, and BIXLS2. The remote comes with batteries and is ready to use immediately. Frequency: 433.92 MHz. Range: 50–100 meters. Pairing is required before use. Four buttons control up to four garage doors. Code: Replaces rolling codes for enhanced security. Batteries included for immediate use; the best replacement. Pairing is required before use. MATERIAL: High-quality and wear-resistant ABS; the buttons are user-friendly, and the slim design makes the remote lightweight, handy, and portable. 24-HOUR SERVICE: The product is shipped after manual inspection to guarantee a high-quality product. Should any problems arise after purchasing the remote control (pairing/frequency/model), please contact us.

Product Features:
Product Specifications:

Frequency: 433.92 MHz.
Number of Buttons: 4 Channels.
Battery Type: CR2032 Batteries.

Compatible Models:

Compatible with DITEC GOL4
Compatible with DITEC BIXLG4
Compatible with DITEC BIXLP2
Compatible with DITEC BIXLS2
Note: Check the LED color before ordering.

Programming is very easy:

1. Open the control unit and locate the receiver. Make sure jumper JR6 on the receiver board is open.
2. Press and hold the black PRG button for 5 seconds – then press and hold the button on the new remote control for 5 seconds to activate the device.
3. Wait 10 seconds for the receiver to reset and test.