4-channel remote control for gates – compatible with Sommer 4025 BLUE, 4031 and F51-051 – frequency 433.92 MHz

Compatible: Remote control for Sommer 4025 BLUE, 4031, F51-051.
Frequency: 868 MHz, Range: 50–100 meters, Pairing required before use. 4 buttons to control up to 4 garage door openers.
Code: Replaces rolling code for increased security. Batteries are included, ready to use, a high-quality replacement. Pairing required before use.
Sliding cover: Prevents accidental activation and protects the buttons from impact damage. The remote control is made of high-quality, durable plastic, finely sanded and polished; the buttons are smooth and comfortable to use.
Scope of delivery: The garage door remote control is shipped after careful manual inspection. Should you experience any problems (pairing/frequency/model) with the remote control after purchase, please contact us. Compatible: Remote control for Sommer 4025 BLUE, 4031, F51-051. Frequency: 868 MHz, Range: 50–100 meters, Pairing required before use. 4 buttons to control up to 4 garage door openers. Code: Replaces rolling code for increased security. Batteries included, ready to use, a high-quality replacement. Pairing required before use. Sliding cover: Prevents accidental activation and protects the buttons from impact damage. The remote control is made of high-quality, durable plastic, finely sanded and polished; the buttons are smooth and comfortable to use. Package contents: The garage door remote control is shipped after careful manual inspection. Should any problems (pairing/frequency/model) occur after purchase, please contact us. Programming: 1. Press the learn button on the radio or keypad once for channel 1; LED 1 lights up. Press it twice for channel 2; LED 2 lights up. 2. Start the transmission by pressing one of the desired CH buttons on the transmitter (within the range of the radio receiver). The LED will flash and then turn off depending on the selected channel. 3. Repeat steps 1 and 2 to program additional handheld remote controls with the corresponding radio receiver. Up to 112 memory locations are available. 4. Press the transmitter button to perform a function test. Note: For information on deleting individual or all transmitter codes from the receiver's memory, refer to the receiver's instruction manual. Deleting All Codes Sometimes it is necessary to delete all codes stored in the receiver, for example, if you lose a remote control. Proceed as follows: 1. Press and hold the Learn button A on the radio receiver. 2. The LED will start flashing after 5 seconds. After another 10 seconds, the LED will light up continuously.
3. After a total of 25 seconds, all LEDs will light up continuously.
4. Release the learning button A: The erasure process is complete. All stored codes, including the illumination codes, should now be erased.
· Verify this by pressing the transmitter button you previously used to operate the device. You should not hear a beep.