433.92MHz Gate Remote Control, Genius Compatible Remote, Garage Door Remote for Echo TX4 433 RC, Echo TX2 433 RC, TE443H Bravo, Pack of 3

REPLACEMENT REMOTE CONTROL - This garage door remote control is a replacement part and not an original part. It is recommended to check the device compatibility list before purchasing. COMPATIBILITY - Compatible only with: ECHO TX4 433 RC, ECHO TX2 433 RC, TE443H BRAVO. FREQUENCY - Ensure your original remote control has a frequency of 433.92 MHz for optimal compatibility. 4 CHANNELS - The remote control has 4 channels to open gates and garage doors with a single command. BATTERIES INCLUDED - The remote control comes with lithium batteries, so it is ready to use. CUSTOMER SERVICE - Our high-quality customer service team is ready to handle all your questions and problems. SPECIAL NOTE: Please do not purchase the remote control if your model is not listed. Access to the receiver is required. Please ensure you have access to your receiver/door opener before purchasing. REPLACEMENT REMOTE CONTROL - This garage door remote control is a replacement part and not an original part. It is recommended to consult the device compatibility list before purchasing. COMPATIBILITY - Compatible only with: ECHO TX4 433 RC, ECHO TX2 433 RC, TE443H BRAVO FREQUENCY - Ensure the original remote control has a frequency of 433.92MHz for optimal compatibility. 4 CHANNELS - The remote control has 4 channels to open gates and garage doors with a single command. BATTERIES INCLUDED - The remote control comes with lithium batteries, so it is ready to use. Description: * Frequency: 433MHz * Code: Rolling Code * Channels: 4 Channels * Material: ABS * Battery: Battery included * Control Distance: 10m-100m (open space) * Programming Method: Receiver Programming

Compatible Models

BRAVO TX4

ECHO TX4 RC

BRAVO TE4433H

Attention:

It is not compatible with 868 MHz.

Please ensure that your remote control is identical to the one pictured and that your model is listed.

Access to the receiver is required.

Please ensure you have access to your receiver/opener before purchasing.

How is programming done?

CODING VIA THE RECEIVER

1 - On the receiver, press the push button for the channel you wish to code - sW1 to program CH1 and sW2 to program CH2. LED 1 or LED 2 will light up

and remain lit to indicate that the receiver is in learning mode.

2 - Press the remote control within 10 seconds and hold down the push button you wish to code for at least 1 second.

3 - If programming is successful, the LED will flash twice.

4 - After coding the first remote control, the receiver remains in learning mode, with the LED continuously lit.

5 - To code successive remote controls (up to a maximum of 256), Repeat the steps from point 2.

6 - When 10 seconds have elapsed since the last remote control was programmed, the receiver automatically exits the learning phase. It is possible to exit the learning procedure manually by pressing one of the receiver's pushbuttons (SW1 or SW2) after the remote control has been programmed.