434.42MHz Remote Control for Garage Doors, Pack of 1, Compatible with Remote Controls 4013 TX02-434-4-XP, 4014 TX03-434-2, 4022 TX03-434-2, 4 Channels

Replacement garage door opener, not original. Compatible models - Remote control compatible with 4014 TX03-434-2 | 4022 TX03-434-2 | 4013 TX02-434-4-XP (NOTE: 868MHz or other frequencies are not supported). Long transmission distance - The garage door opener remote control can automatically detect the signal; the normal transmission distance is 10 to 30 meters. Portable design - The garage door opener remote control has a retractable design, which is not only dustproof and waterproof but also very compact and doesn't take up much space. After-sales service - If you have any questions, please contact us and we will reply within 24 hours. 4022 TX03-434-2 | 4013 TX02-434-4-XP (NOTE: 868MHz or other frequencies are not supported); Long transmission distance - The garage door remote control can automatically detect the signal; the normal transmission distance is 10 to 30 meters.; Portable design - The garage door remote control has a retractable design, which is not only dustproof and waterproof, but also very compact and doesn't take up much space.; After-sales service - If you have any questions, please contact us and we will reply within 24 hours.;;; Technical specifications: Decoder IC: Rolling Code; Frequency: 434.42 MHz; Battery: Included; Transmission distance: 10-50 m in open spaces. Compatible Models: TX03-434-2-XP TX03-434-4-XP 4013 TX02-434-4 OPEN 4014 TX02-434-2 OPEN 4013 TX02-434-4 OPEN 4013 TX03-434-4 OPEN 4022 TX02-434-2 Our garage door remotes only work with Sommer green LEDs with SOMloq1 coding. Special Note: Not compatible with SOMER 868MHz. Programming: The remote has the same function as the original remote. You must program it with the original receiver according to the original manual upon receipt. 1. Locate the learning/coding button on the motor. It is usually located under the light cover or on the back of the motor. 2. Press and release the learning/coding button once. An indicator light should illuminate. 3. Press the desired transmitter button once; the indicator light will turn off. 4. Press the handheld transmitter button again. The indicator light will flash and then turn off, indicating that the handheld transmitter has been coded. 5. Test the remote control's operation.