Analog-to-digital 0-10V PWM board, signal-to-voltage converter, durable for interface switching, 1 piece

Features:1.PWM converts digital signals to an analog signal (0 to 10V).
2.The input digital signal can be a 0-100% PWM signal at 5V or 24V.
3.The output analog signal can be a voltage from 0 to 10V.
4.Can be used for industrial PLC control panels or other signal interface switching.
5.This module is easy to wire and convenient to use.
Specifications:Features:
PWM converts digital signals to an analog signal (0 to 10V). The digital input signal can be a 5V or 24V PWM signal, 0-100%.
The analog output signal can be a voltage from 0 to 10V.
Can be used for industrial PLC control panels or any other signal interface switching.
This module is easy to wire and convenient to use.
Specifications:
Condition: 100% brand new and high quality
Current: Max.12 mA
Power input voltage: 12-30 V
Size: approx. 5 x 4.5 cm / 1.97 x 1.77 inches
Weight: 20 g
Quantity: 1 pc
Usage Method:
PWM Signal Input Frequency Range: 1 kHz - 3 kHz
PWM Signal Input Level Range:
4.5 V to 10 V peak-to-peak, jumper inserted at 5 V.This type of signal is primarily intended for conventional industrial control boards (such as MACH3 boards), for 5 V for the CPU interface.
Peak-to-peak level: 12 to 24 V, jumper inserted at 24 V.This type of signal is primarily intended for conventional PLC interfaces. Explanation of the 0-10V analog voltage output: When the signal input port is not connected, the output port outputs 0V.The first time we turn on this module, it is better to calibrate it: find a 50% duty cycle signal, connect it to DIN-, DIN+, the amplitude corresponds to the corresponding jumper. When the frequency is between 1kHz and 3kHz, use a multimeter to test AO, GND. The meter should read around 5.4V. We adjust the potentiometer on the converter module so that the multimeter displays approximately 5.4 V. Once this was done, we calibrated and matched the pulse signal with this converter module. The module has a definition of 0.1V. Output current 10mA. If the duty cycle is opposite to the voltage, we can select the PWM STEP LOW/ACTIVE output pin for MACH3 software.
Package included:
1 x PWM signal to voltage converter
Note:
After power on-up, when there is no input signal, the output is 0V.There is no output unless there is an input.