DDS Signal Generator FG-200 Module Frequency 0.01 Hz to 500 KHz Output Square Sine Sawtooth

I.The main technical parameters:
1. Output waveforms: sine wave, square wave, triangle wave, sawtooth wave, reverse sawtooth wave, ECG wave, exponential rise, exponential fall, Lorentz pulse, Gauss pulse, Sinc pulse, half wave, full wave, wave, noise wave, and so on 15 kinds of waveforms.
2. Power supply: DC4-9V, DC5V is recommended when using an adapter, 3.7V lithium battery is recommended when using battery.
3. Current: 180MA at voltage 5V
4. Frequency range: sine wave 0.01 Hz-500.00 kHz (with further increase in frequency, the output amplitude will decrease), other waveforms 0.01 Hz-100.00 kHz (but does not limit the upper limit of the adjustable frequency, if the distortion and jitter requirements are not high, the frequency utilization can be further increased).

5.Resolution: 0.01 Hz.
6. Sine wave distortion: minus 1% below 1 kHz, minus 0.5% above 1 kHz.
7. Output amplitude: T10 V maximum (PP).
8. output impedance: 50 ohms.
9. DC offset: maximum 10V, with shutdown function.
10. all configuration parameters can be saved.
11. There are filters that can be turned on and off, can be well matched to sine and pulse waveform output.
II. Features:
Compact size (125x80x26.5MM), complete functions, simple operation, easy to carry. This can be
powered by an AC adapter or a 3.7V lithium battery. With an oscilloscope, it can be used for electronic circuits testing and debugging, frequency characteristics and testing and measuring impulse response of audio amplifiers.Due to the precision and frequency stability of the DDS, it is also very suitable for the calibration of the oscilloscope's sweep time factor. The
Square wave output is suitable for oscilloscope attenuator and pulse characteristic adjustment of the probe
Note: Due to different production batches, there may be slight differences between products.
Color: Color as pictured
Material: Plastic

Package contents:
1 * FG-200 DDS Signal Generator

Only the package above, other products are not included.
Note: Light reflection and different displays may cause the color of the item a little different from the real thing. The allowable measurement error is +/- 1-3 cm.