DN20 Adjustable Brass Water Pressure Reducer with Pressure Gauge, Adjustable Brass Water Pressure Reducer (DN20 3/4 inch)

Technical Specifications: Material: Brass. Maximum Load: 16 kg/cm². Maximum Gauge Dimensions: 0.05 – 0.8 MPa (7.25 – 116 psi). Connector Size: DN20. Inlet Pressure: 1.6 MPa (Max) / 232 PSI. Weight: 425 g. Package Contents: 1 x Pressure Gauge. 1 x Brass Water Pressure Reducing Valve. Note: The direction of water flow from the valve body installation must strictly match the direction marked on the valve. If the direction is incorrect, the water pressure gauge will not function. After installation, adjust the valve to a suitable pressure range to prevent excessive pressure from damaging the gauge, or the gauge from malfunctioning if the pressure is too low. Installing a water pressure reducing valve will resolve the issue. The water pressure is too high, the electric water heater is making an abnormal noise, the safety valve is ticking, and there's a sound of water loss. The water pressure is too high, exceeding the 0.3 MPa water pressure of the water purifier. The water pipes often burst, and water overflows. Jinshan 6 Main Advantages: Filter Design/Clogging Prevention: The water inlet is equipped with a stainless steel filter that can filter particles in the water to protect the valve body from damage and extend its service life. Thickened Interface/Clear Thread: The main body features a forged wire interface design with thickened, single-pass construction for easy installation and no water loss. Adjustable Design/Pressure: Different pressure values can be set, allowing for a wide range of applications. Valve Body Indicator/Installation Direction: The pressure reducer can be installed horizontally or vertically. The flow direction must be the same as indicated on the valve. Manual pressure adjustment method: Using the hexagonal pressure adjustment key, the pressure can be adjusted according to the actual water pressure. You can directly turn the protective cover on the top of the pressure reducing valve counterclockwise to remove it by hand, insert a hexagonal key into the hole to adjust the water pressure: 0.05 - 0.8 MPa (7.25 - 116 psi) - Suction pressure: 1.6 MPa (maximum) / 232 PSI. Turn counterclockwise to decrease the water pressure. Turn clockwise to increase the water pressure. Pressure gauge installation method: The pressure reducing valve is equipped with a pressure gauge interface. By installing a pressure gauge, the real-time pressure can be intuitively recorded. The pressure gauge can be installed and connected to the outlet of the pressure reducer. First, use an adjustable wrench to remove the cap on the pressure gauge interface, then install it. The interface is already equipped with a sealing gasket; there is no need to directly screw the strap onto the raw material for installation.