DN20 Brass Adjustable Water Pressure Reducer with Pressure Gauge, Brass Adjustable Water Pressure Reducer (DN20)

HIGH QUALITY: The water pressure reducer valve is made of brass, durable and easy to install. Suitable for cold and hot water CONVENIENCE: The water pressure regulator can reduce the water pressure and also make it stable. Easy to adjust, simply adjust the brass screw (top on regulator) to change pressure - or + GOOD FUNCTIONALITY: This pressure reducing valve adopts piston structure, simple internal structure, strong environmental use, durable to use. APPLICATION: Hydraulic instability, water flow too fast, water purifiers, solar energy, gas heater and faucet. EASY TO USE: Compact size for easy use, the removable valve spool for easy cleaning or replacement when needed by removing it. Technical characteristics: Material: brass. Maximum load: 16 kg/cm². Maximum log dimensions: 0.05 – 0.8 MPa (7.25 – 116 psi). Connector size: DN20 Inlet Pressure: 1.6 Mpa (Max) / 232 PSI. Weight: 425g. Package Contents: 1 x pressure gauge. 1 x Brass Water Pressure Reducing Valve. Note: The water flow direction of the valve body installation must be strictly consistent with the direction marked on the valve. If the direction is wrong, the water pressure gauge will not be indicated. After installation, adjust the valve within an adequate pressure range to prevent excessive pressure from damaging the pressure gauge or the pressure gauge does not work if the pressure is too low. Only the need to install a water pressure reducing valve can help you solve the problem. The water pressure is too high, the electric water heater has an abnormal noise, the safety valve ticks and the sound of water loss. The water pressure is too high of the water purifier water pressure 0.3 MPA. Water pipes often burst and water overflows Jinshan 6 main advantages Filter design/clogging prevention The water inlet is equipped with a stainless steel filter / can filter particles in the water to protect the valve body from damage / extend the service life. Thickened interface/clear wire. The main body is made of one-pass forging/thickening wire interface design/easy installation and no water loss. Adjustable/pressure design It is possible to set different pressure values / a wide range of applications. Valve body flashing / installation direction. The pressure reducer can be installed horizontally or vertically. The flow direction should be the same as indicated on the valve. Manual pressure adjustment method. Using the hexagonal pressure adjustment wrench, the pressure can be adjusted according to the actual water pressure. You can directly turn the protective cover on the upper part of the pressure reducing valve counterclockwise to remove it by hand, insert a hex wrench into the upper hole to adjust the water pressure: 0.05 - 0.8 MPa (7.25 - 116 PSI), Suction pressure: 1.6 MPa (maximum) / 232 PSI. Turn counterclockwise to reduce water pressure. Turn clockwise to increase water pressure. Pressure gauge installation method. The pressure reducing valve is reserved with a pressure gauge interface by installing a pressure gauge, the real-time pressure can be displayed intuitively. The pressure gauge can be installed and connected to the outlet of the pressure reducer. First use an adjustable wrench to remove the cap on the pressure gauge interface, then install. When installing, the interface is already equipped with a seal, there is no need to directly screw the raw material strap for installation.