Electric Soldering Iron Tin Suction Sucker Pen Desoldering Soldering Tool (EU Plug 220V)

1. Used for various electronic soldering and tin suction. 2. It is convenient to remove the components to be replaced from the board without damaging the components and the board. 3. Can be used to replace integrated circuits, multi-pin switches, etc. 4. This box can be used as an electric soldering iron. It is an indispensable tool for national defense, scientific research, communication, aerospace, computer, radio, television, electronic professional maintenance personnel and the majority of radio enthusiasts. 5. The medium size is easy to hold and suitable for one-handed use. Specification: Features: 1. Used for various electronic soldering and tin suction. 2. It is convenient to remove the components to be replaced from the board without damaging the components and the board. 3.Can be used to replace integrated circuits, multi-pin switches, etc. 4. This box can be used as an electric soldering iron. It is an indispensable tool for national defense, scientific research, communication, aerospace, computer, radio, television, electronic professional maintenance personnel and the majority of radio enthusiasts.siasts. 5. The medium size is easy to hold and suitable for one-handed use. Specification: Condition: 100% Brand New Item Type: Soldering Iron. Material: plastic handle + stainless steel tube. Power: 30W Temperature adjustment range: 400°C Voltage: EU plug 220V Package list: 1 * soldering iron 1 * nozzle 1 * PCB needle Note: 1. Please allow slight error due to manual measurement. Thank you for understanding. 2.Monitors are not calibrated same, item color displayed in photos may be showing slightly different from the real object. Please take the real one as standard. 3. Please note if you need a plug adapter. Instructions: 1. Turn on the power and heat for 3-5 minutes. 2. Push the plunger handle down and the front end of the suction soldering iron nozzle is aligned with the solder joint of the component to be removed. Once the solder is melted, press the control button and the solder is drawn into the intake cylinder. 3. The suction device is equipped with two nozzles of different diameters, which can be selected depending on the thickness of the component wires. 4. When soldering, same operation as with an electric soldering iron 5.When disassembling the pneumatic cylinder, press the upper end of the pneumatic cylinder downward in the direction of the arrow. When the pneumatic cylinder and the handle are separated, the pneumatic cylinder can be separated. When the suction nozzle is removed, the suction nozzle is rotated counterclockwise relative to the suction nozzle. Withdrawal Considerations 6. Check whether the voltage used is consistent, too high or too low voltage is not suitable for use 7. Before use, tighten the suction nozzle and air cylinder to prevent air leakage, otherwise it will affect the absorption effect of the tin. 8. Frequently remove the solder impurities entering the nozzle and gas cylinder, and add a little oil to the piston. 9.After each use, push the plunger 3-4 times to remove residual solder in the straw, so that the nozzle and straw are unblocked for the next use. 10. After the suction device is powered on, it is strictly prohibited to install and disassemble its electrical parts. 11. When the new welding device is used for the first time, it may be slightly smoked due to heating of the heating element. This is a normal phenomenon and will disappear naturally after ten minutes. 12. During use, the soldering iron seat with natural heat dissipation structure should be used and should be placed in the soldering iron base. 13. If the power cord is damaged, it must be replaced by the manufacturer or its service department or similar professional to avoid danger. 14.This product has a ground wire, it must be used with a socket with contacts, please pay attention to use, for safety reasons