Electronic pH Tester, 5-in-1 Pool Water Tester with Backlight, pH/TDS/EC/Salinity/Temperature with ATC, High Precision pH Meter with 0.01 Resolution, for Drinking Water, Aquarium, Spas

【5-in-1 Function】 This is a water testing kit with a pH tester, TDS meter, and EC salinity/temperature tester. The backlit LCD screen makes it easy to read the displayed values.【Easy to Use】 Press the power button to turn on. Press "HOLD" to lock the value, press and hold "HOLD" to change the temperature unit. Press "MODE" to switch between the different functions.【Absolute Accuracy】 pH resolution is 0.01 pH, accuracy ±0.05 pH. TDS meter resolution is 1 ppm (0.1 ppt), accuracy ±2%. Conductivity resolution is 1 µS/cm (0.1 mS/cm), accuracy ±2%. Thermometer resolution is 0.1°C/°F, accuracy ±0.5°C. Salinity resolution 0.01%, accuracy 0.01-5.00% (±0.1%), 5.10-25.00% (±1%)【Wide Application】 Ideal for home or laboratory use. Suitable for testing the pH balance of drinking water, swimming pools, aquariums, RO systems, spas, or hydroponic systems.【Robust and Durable】 This pool tester is IP67 waterproof, so it can continue to be used even if it falls into the aquarium.Please try to avoid using this pH meter to measure concentrated acid or alkali solutions. Otherwise, its accuracy and lifespan will be affected.Once the pH meter is switched on, the probe will detect the pH value of the air or residual solution on the surface of the sensitive bulb, so the pH reading will appear irregular, which is normal.It is normal for readings to fluctuate up and down during testing. Never take a reading immediately after placing the probe in the solution. To read a pH meter, always wait for the reading to stabilize.After each measurement, rinse the probe with distilled or pure water for 5 to 10 seconds and dry it before measuring the next solution. Otherwise, the results will be inaccurate.The sensitive bulbs are made of very fragile glass. Do not touch with hands or other hard objects and do not use this pH meter to test solutions above 50 degrees Celsius. If the electrode is left in place for a long time and is exposed to air, the readings will be slow and unstable due to the electrode drying out. You must immerse the electrode in water for a few hours and recalibrate the device before use.Automatic calibrationBacklit LCD screenIP67 WaterproofAutomatic shut-offEasy to useLock the value/temperature switchPress the "ON" button to turn on, press the "HOLD/TEMP" button to lock the value, and press and hold "HOLD/TEMP" to change the temperature unit.Use the mode switchPress the "ON" button to turn on, touch "MODE/CAL" to switch between modes.Fast and accurate calibration of pH meters1. Before calibration, add the pH4.00/pH6.86/pH9.18 buffer powder to a container with 250 ml of distilled water and stir until the powder is completely dissolved.2. Press the "ON/OFF" button to turn on the pH meter and switch to pH mode.3. Place the electrode in the pH4.00 standard solution and wait for the reading to stabilize (usually 5 to 10 seconds).4. Press and hold the MODE/CAL button for 6 seconds and release it until the pH4.00 reading stops flashing and the pH4.00 calibration is complete.5. Repeat the steps above to complete the pH 6.86/pH 9.18 calibration in order. NOTE: Always strictly follow the calibration sequence of pH 4.00, pH 6.86, pH 9.18. Otherwise, the calibration result will be inaccurate.