Fluid transfer pump, oil extraction pump, for hydraulic fluid

Features: 1. Widely used in general industrial equipment 2. Maximum pressure: 0.8 MPa 3. Ideal equipment for quick and clean oil changes 4. Operates by connecting the clamps to a 12V car battery 5. Connect the car battery to start and stop; easy to use Specifications: Description: This oil extractor transfer pump uses a 12V mini self-priming pump to change car engine oil. It operates by connecting the clamps to a 12V car battery and is widely used in general industrial equipment, as this pump can not only pump oil but also hydraulic oil and other liquids. It is ideal equipment for quick and clean oil changes. Features: 1. Widely used in general industrial equipment. 2. It works by connecting the clamps to the 12V car battery. 3. An ideal piece of equipment for quick and clean oil changes. 4. Connect the car battery to start, turn it off, easy to use. Specifications: Rated Voltage: DC 12V Rated Power: 60W Maximum Pressure: 0.8 MPa Maximum Flow Rate: 5 L/min Pump Diameter: approx. 4.8 cm / 1.89" Length: approx. 14.5 cm / 5.7" Outlet Hose Size (Dia. x L): approx. 11 mm x 140 cm / 0.43" x 55" Inlet Hose Diameter: approx. 8 mm and 6 mm / 0.31" and 0.24" Inlet pipe length: approx. 100 cm / 39.37" Cable length: approx. 30 cm / 11.8" Clip length: approx. 8 cm / 3.15" Main Color: Black Application: Widely used in general industrial equipment, chemical equipment, shipbuilding, beverages, carpet and floor cleaning, water purification and treatment equipment, vehicle cleaning, agricultural spraying, pipelines, pressure, air cleaning, cooling, coal and metallurgical industries. How to Use: 1. Start running the car engine for a while. When the oil temperature reaches approximately 50 degrees Celsius, begin pumping oil. 2. Connect the pump to the power supply, run it for a while, and observe if the inlet and outlet are normal. 3. Open the filler cap, remove the dipstick, and force the tube into the bottom of the seal until the tube is fully inserted and does not move. Then, place the oil dipstick inlet hose at the end (the tube at the bottom). of the tank, the concave area at the bottom, in order to pump the oil completely (because no oil, or pumping very slowly, or intermittently, is usually due to loose hoses and fittings. You must reinstall the hoses and fittings.) 4. After pumping the oil, remove the tube, then run the pump for a while, pump the remaining oil inside, or pump water for a while until the pump head is clean. 5. If you haven't used it for a long time, there may be no suction, so simply pour water into the pump and run the pump for a few minutes until all the air is expelled. Package included: 1 x Oil pump 1 x 11mm outlet hose 1 x 8mm inlet hose 1 x 6mm inlet hose 2 x Clips Note: 1. Please allow for a 1-3 mm error due to manual measurement. Thank you for your understanding. 2. If you wish to connect this pump to mains power, you will need a power converter. 3. Please use when the engine is warm, the engine oil is warm and its viscosity is lower; it will be easier and faster to pump. 4. This product is not suitable for pumping corrosive liquids, strong acids, or highly alkaline liquids. 5. Please note that the new and old types of this product will be sent randomly, and please ensure this is acceptable to you before ordering.