Makita AN613 Pneumatic Coil Nailer Air Pin Gun and 9000 2.3 50mm Flat Coil Nails

The Makita AN613 Nailer is designed to perform tasks such as framing, fencing, interior & exterior nailing

Actuation Mode Selector – select operation mode: single sequential actuation mode (single fire) or contact actuation mode (bump fire).
 Nail depth adjustment – to adjust the depth of nailing, turn the adjuster. The guide on the tool shows which direction for deep or shallow depth. If nails are still not driven deep enough after adjustment, increase the air pressure. If nails are too deep after adjustment, decrease the air pressure.
 Air duster – helps clean dust and debris off material. Press the button on the grip end to engage.
 Hook – convenient for hanging the tool temporarily. To change the hook position, remove the hex socket bolt and switch hook direction.
 Easy to-grip handle – Anti-slip ribs added to the grip rubber provides more control.
 Nose adapter – use the adapter to prevent the surface of the workpiece from being scratched or damaged. Drive Nails 38-65mm in length with 300 nail magazine capacity Cylindrial striker ideal for twist, ring and standard nails
 0.49-0.83MPa (70-120psi) operating pressure
 Tool-less depth adjustment for recessing heads
 Air blower cleans material of dust and chips from workpiece Supplied with high performance coil nails from Tacwise. Shaft of the nail has inset rings to assist with the holding power of the nail. These coils have a flat collation and can be used in most coil nailers handling 2.3 diameter nails. These coil nails have a bright, untreated finish (no coating).