[6pcs] 12x120mm Concealed Floating Shelf Bracket Wall Mounted Shelf Brackets & Brackets Heavy Duty Invisible Bracket Hidden Shelf Brackets for Custom Wall Shelves Planks

• ?Concealed fixed support? : Can be used for DIY or custom molding, completely hidden in walls and boards, simple and fashionable, and makes your home more beautiful and tidy.
• ?Material?: The interior of the floating shelf bracket is made of iron, its housing and expansion tube are made of plastic. It is a good finish and durable.
• ?Dimensions?: The total length is 195mm, the length of the expansion tube is 75mm, the diameter is Ø12mm, and the length of the support rod is 120mm, the diameter is Ø12 mm.
• ?High stability? : The support rod is a hexagonal cylinder with nubs which increases the blocking of the board and improves stability.
• ?Strong load-bearing capacity?: The load-bearing capacity of the wall-mounted shelf bracket is very strong. When properly installed on a suitable solid wall, the bracket can support approximately 20 kg.

[Dimension]:

Total length: 195mm

Expansion tube length: 75mm, diameter: Ø12 mm

Support rod length: 120 mm, diameter: Ø12 mm

[Package]:

6 X concealed floating shelf bracket

The plank bracket & nbsp; can support and fix all kinds of wall shelves such as bookshelves, display racks, garage shelves, decoration shelves, bathroom shelves, shoe racks, etc.

It can definitely satisfy your various DIY wall mounting designs.

Installation steps:

1. First measure the hole spacing and drill the hole in the wall. The depth of the hole should not exceed 75mm.

2. Insert the extension end of the bracket's support pin, along with the black screw cap on the end, into the hole in the wall.

3. Insert the handrail into the expansion plug in the wall opening. After the end of the screw has been properly contacted with the screw cap and tightened clockwise, continue to rotate until the expansion plug expands into the wall, to fully support the wall.

4. Then drill the appropriate size hole in the side of the panel (according to the distance between the holes in the wall).

5. Finally, insert the circuit board into the board holders.

Please read the following tips:

1. To drill holes, you need to prepare a 12mm drill bit.

2. Remember to place the silver metal center ring on one side of the expansion pipe and embed it in the wall.

3. Each plank must have at least two invisible supports and be maintained in the same horizontal position.

LRFR is committed to providing each customer with the highest standard of customer service.