RCBO 1P+N 10A C curve 6kA EN61009

1) 2-in-1 protection: circuit breaker + residual current device, to keep your circuits safe every dayThis 1P+N C10A RCBO combines in a single module protection against overloads and short circuits (like a standard circuit breaker) as well as residual current protection against current leakage (reducing the risk of electric shock). Installed on a DIN rail in a consumer unit, it cuts off the power supply as soon as an anomaly is detected, which helps limit conductor overheating, equipment damage and incidents linked to humidity or faulty insulation. It is a particularly relevant solution when you want both power supply stability and people’s safety on the same circuit.2) 1P+N format: ideal for common single-phase installations, clearer wiringThe 1P+N (phase + neutral) configuration is designed for the most common single-phase circuits in homes and small commercial premises: the phase is protected and controlled, and the neutral is associated for consistent disconnection of the circuit. This format makes organisation in the consumer unit easier (circuit identification, maintenance), particularly during renovation, bringing a home up to safety standard, replacing equipment or creating dedicated lines. For specific requirements (three-phase, selectivity, particular layouts), the number of poles matching the installation should be chosen.3) 10 A rating + C curve: suitable for light circuits and moderate inrush currentsWith a rated current of 10 A, this model is particularly suitable for moderately loaded circuits: lighting, small equipment, low-power sockets or local circuits (e.g. kitchen/bathroom areas as part of a compliant setup). The C tripping curve offers a good compromise: it better tolerates certain start-up inrush currents (small motors, power supplies, transformers, appliances with a slight switch-on peak) while still maintaining effective protection in the event of a fault. Result: fewer nuisance trips linked to normal start-up, and more comfortable day-to-day use.4) Complies with EN/IEC 61009, 6 kA breaking capacity: a relevant choice for homes and small commercial premisesComplying with EN 61009 (RCBOs with overcurrent protection), this device fits within a safer selection approach for projects where equipment meeting a recognised technical standard is required. Its 6 kA breaking capacity corresponds to a level commonly used in residential final distribution and light commercial premises, to withstand and interrupt a short circuit under the conditions предусмотренные by the manufacturer. As always in electrical work, final suitability depends on the prospective short-circuit current at the installation point: if in doubt (old building, particular supply, proximity to a transformer), sizing or checking by a professional remains best practice.5) Wide network compatibility: AC 230-400 V, 50/60 Hz — installation and use recommendationsDesigned for use on AC 230-400 V and 50/60 Hz, it covers the majority of configurations encountered depending on the site. For reliable use, it is recommended to follow best practice: correct tightening of the terminals (avoiding any hot spot due to poor contact), choosing protection consistent with conductor cross-section, line length and the thermal conditions of the consumer unit. This C10A is not intended to supply high-consumption appliances (water heater, oven, air conditioning, hobs, etc.) which generally require a higher rating and a dedicated line. For a compliant and safe result, installation and testing (wiring check, trip verification) should be entrusted to a qualified electrician.