Solar Charge Controller Panel, 6V 3A Battery Discharge Regulator for Light Lamp

Features:1. Intelligent Control: This solar charge controller allows for light control, time control, commercial control, etc., and is very reliable.
2. Safe Charging: Comes with a 3-stage PWM charging mode: solid charge, balanced charge, and float charge.
3. Higher Safety: Also features overload protection, over-discharge protection, overcurrent protection, short-circuit protection, and reverse connection protection.
4. Good Match: Ideal for 6V battery systems, the battery regulator is available in both household and street-type designs.
5. Easy to install: Designed to be lightweight and compact, installation is very convenient.
Specifications:Item Type: Solar Charge Controller
Model: JC0603
Material: ABS
Application: For solar charging and discharge control.
Nominal Voltage: 6V
High Load Voltage: 7.4V
Balanced Load Voltage: 7.25V
Floating Voltage: 6.85V
Under Voltage Protection: 5.4V
Brunchout Recovery: 6.5V
No Load Current: ≤6mA
Load Circuit Voltage Drop: ≤0.2V Discharge Circuit Voltage Drop: ≤0.2V ≤0.1V
Maximum Load Current: 3A
Maximum Load Current: 3A
Controller Protection: Overload protection, reverse connection protection, over-discharge protection, overcharge protection, short circuit protection, etc.
Charging method: PWM regulation method
Rain control: Wait until the device is submerged in water to allow it to soak in the rain control line.
Operating altitude: ≤ 5500m; above 2000m, power consumption needs to be reduced.
Operating temperature: -20℃ ~ 55℃
LED status function
Charging is off at night or when the battery is not connected.
Always on the battery in equalization charging mode.
Green light on the controller's normal output.
Green light on the controller's output protection.How to use:
1. Installation environment: Install in a dry, well-ventilated area.
2.Wiring method:
A.Battery: the positive terminal is on the left; ensure the connection is correct.
B.Then connect the battery floor, the positive pole is on the left, the connection is correct, the charging indicator light is on, and it enters the charging state. Otherwise, check the wiring.
C. Connect the light source again, the bulb and the positive pole are on the left, the connection is correct, the bulb is on. In addition, the street lamp type light is long during the day, and the lower voltage and voltage are off for a long time. Otherwise, check the wiring.
D. Finally, connect the rain control line, connect the rain control line to the sink above the lamp and check whether it is reliable. The rain control line should not be too long, no more than 1 meter. Too long will affect the rain control sensitivity. The shorter it is, the more sensitive it is.
Note: The steps above must be connected in order, otherwise the controller will be damaged.
3.The controller contains a DIP switch, synchronizing codes 8421, so the user must open the shell for proper operation.After opening the shell, you can see the DIP switch.The specific operations are as follows:
The DIP switches, 1234, correspond to the timer, 8421, respectively:
A.If the user needs to set the timer for 6 hours, simply dial the corresponding positions 2 and 3 to set the LED light to be on for 6 hours at night. For example, if the time is 11 o'clock, simply dial the corresponding numbers 8, 2, and 1.You can set the LED light to stay on for 11 hours at night.
B.If the user enters all the dialing codes, 8421, at the top, the controller will default to Full Light Control
C.If the user enters all the dialing codes, 8421, at the bottom, the controller will default to User System and the charge will have a 24-hour output.

Package List:1 xsolar charge controller