1/4
STC-1000 Digital Temperature Controller, Heating and Cooling Thermostat, with Sensor, Model: 110/220V
Sold by Selphora
You may also like
Compare with similar items
Product information
Description
This digital temperature controller is easy to use and operate, making it particularly suitable for domestic freezers, water tanks, refrigerators, industrial chillers, boilers, steamers, and industrial equipment. Features: Miniature temperature controller with a large, clear LED display for easy reading. Switching between cooling and heating modes. Temperature control is achieved by setting the setpoint and differential. Temperature calibration and protection against cooling regulation output delays are supported. An alarm function ensures safety in case of limit exceedance or sensor failure. High-temperature start-up corresponds to the cooling mode, set to °C. Low-temperature start-up corresponds to the heating mode, set to °H.P1 Differential Speed Setting Heating mode (H): When the heating power starts and stops at the setpoint, the measured value is ≤ the defined difference. Cooling mode (C): When the cooling power starts and stops at the setpoint, the measured value is ≥ the setpoint + differential.P2 Maximum setting range: The maximum value at the set temperature does not exceed this value.P3 Minimum setting range: The minimum value at the setpoint temperature must not fall below this value.P4 Temperature correction This function corrects any difference between the measured temperature and the reference temperature. Corrected temperature = uncorrected temperature + correction value.P5 Start-up delay (unit: minutes). When controlling compression equipment for cooling, you can set a delay as needed. After the controller outputs a signal, the equipment does not start immediately; It must wait until the end of the defined time. P6 High Temperature Alarm. When the measured value exceeds this value, the screen displays an alarm, a descending alarm, and the output disconnects. P7 Data Lock Function. Enabling the data lock preserves the current settings. The temperature and setting functions are disabled. To make any changes, you must disable the data lock function. P8 Factory Reset. Press and hold the SET button to access P8, press SET once to activate, and then press Rst to reset to factory settings. You can also press and hold the + and - buttons to perform the POST and reset to factory settings.
Features
- BrandOTHERS
- ColourBlack
- Thermostat typeCorded
- Compatible equipment typeBoiler
- Integrated temperature sensorYes
You are here:
'/%3E%3C/svg%3E){kind=small}