Wind Turbine Generator Charge Controller Automatic Wind Turbine Generator Charge Regulator FW12/24 12/24V 300W/600W Waterproof IP67

Product Specifications: Model: FW12/24; Battery Nominal Voltage: 12/24V; Wind Turbine Nominal Power: 300W/600W; Brake Start Voltage (Factory Value): 14.5V/29V; Brake Recovery Voltage (Factory Value): 13.2V/26.4V; Display Mode: LED (Light Emitting Diode Display); Operating Temperature and Humidity Range: -35°C to -75°C; Quiescent Current: 15mA; Protection Level: IP67. Fully Waterproof: This wind turbine controller adopts a fully waterproof design, with a protection level exceeding IP67. Superior Quality: This brand new wind turbine controller, made of high-quality material, is robust and durable. The braking circuit and rectifier section of the controller adopts an integrated module design, which offers reliable quality and a long service life. Automatic Control: This controller automatically controls the wind turbine to charge the battery. When the battery is full, the fan is braked by the automatic control of the internal circuit. When the battery voltage drops below the recovery voltage, the fan resumes charging the battery, thus protecting both the fan and the battery. 12V 48V Wind Turbine Regulator, Wind Turbine Charge Controller, Wind Turbine Charge Controller, 12V MPPT Wind Turbine Regulator, 12V Battery Charge Controller for Wind Turbine, 12V Three-Phase Wind Turbine Regulator, 1000W Wind Turbine, Wind Turbine Charge Controller, Windmill Brake. Specification: Condition: 100% Brand New Model: FW12/24 Battery Rated Voltage: 12/24V Wind Turbine Rated Power: 300W/600W Starting Brake Voltage (Factory Value): 14.5V/29V Recovering Brake Voltage (Factory Value): 13.2V/26.4V Display Mode: LED (Light-Emitting Diode Display) Operating Temperature and Humidity: -35°C to -75°C Quiescent Current: 15mA Protection Level: IP67 8b0f0ea7316bb5252dda3c149b6c045d 68b329da9893e340255g Size: Approx. 100 * 87 * 28mm / 3.9 * 3.4 * 1.1in Wiring: 1. Connect the positive and negative terminals of the battery to the positive (red) and negative (black) battery terminals. 2. Connect the three-phase output voltage of the wind turbine to the three-phase input terminal (green line) of the fan controller. Package List: 1 * Wind Turbine Controller Note: 1. Verify that the output voltage of the wind turbine matches the rated voltage of the battery. 2. Wiring sequence: First connect the positive and negative terminals of the battery, then connect the three-phase voltage output of the fan. 3. Please connect the battery and wind turbine to the controller, carefully following the instructions. If the polarity is reversed or if the connection is incorrect, the system will malfunction and may even cause significant damage to the controller. https://m.media-amazon.com/images/I/51uAOPfdRaL.jpg