5mx 5cm Anti Slip Tape with Luminous Film Glow in the Dark, Safety Tape for Stairs Ladders Slippery Floors Indoor and Outdoor,

LUMINOUS REMINDER: The tape with green fluorescence film will glow in the dark So you can use it to highlight the stairs and easier to see to avoid tripping on the last step at night.

ADD GRIP TO PREVENT SLIP: The tape is made from 80 grit aluminum oxide which creates superior and durable traction on the slippery area. So you don't have to worry about slipping and you will feel safer going up or down the stairs.

DURABLE ADHESIVE & FREE RESIDUE: The high quality glue is resistant to cracking and peeling. At the same time, when you need to replace or reposition, it will not leave any residue and will not damage your flooring.

SUITABLE FOR SCOPE: Ideal for highlighting stair nosings, dangerous steps. Such as loading dock edges, basement stairs, movie theater stairs, bunk bed ladders, garage and any other potentially hazardous areas.

APPLY SIZE: Easy to install and use, just peel the stick and roll out the bubbles; Size: 50mm width x 5m length, Luminous.

Specification

Main material: gravel, paper, strong glue, fluorescen

Applicable temperature: 14-140 / -10-60

Suitable for: flat, clean, smooth and hard floors or surfaces (eg floors, stairs, steps, corridors, ramps, vehicle steps, fire escape ladders, scaffolding, cinema aisles, etc.)

Not suitable for: rough, soft, wet, dusty or porous ground

HOW TO USE?

Make sure the contact surfaces are flat, clean and dry when applying it.

Cut the tape to the desired length and round the corners with scissors.

Peel off the release paper and place it in the desired location. (When the temperature is low, slowly heat with a hair dryer and gum with good results).

The pressure is applied evenly from the center of the strip to both ends. (The applied strip has waited for 24 hours)

Place the tape on a light source for a while to make it glow in the dark.

Tips

The tape absorbs 15-20 minutes. The light source can remain light for a while. (The more light is absorbed, the lighter and more durable the light is, and then it is slowly weakened)

If the luminous line is dim, no problem, it is rather bright immediately after "charging" with light.