5T Hydraulic Puller, Wheel Hub Puller with 3 Pulling Jaws for Traction Hubs, Flanges, Gears and Bearings

【Sturdy and Durable】This forged steel hydraulic puller is very strong and durable, with good capacity and a long service life. 【Adjustable Pulling Jaws】: It is equipped with 3 pulling jaws that can be adjusted from top to bottom and can be pulled with two or three feet depending on your needs. 【Labor-Saving and Safe】: There is a handle that can be opened, allowing for very light operation and high pulling force. The safety overflow valve control switch on the pump body is ready to prevent oil pressure overload. 【360-Degree Pump Head】: The hydraulic puller features a 360-degree pump head design, making it easy to operate and use. After rotation, it can quickly contact the working center based on the distance between the puller and the center of position. 【Application】: Suitable for traction hubs, flanges, gears, and bearings with a maximum capacity of 10 tons. Features:  Material: Carbon steel + cast iron.  Stroke: 50mm.  Maximum capacity: 5 tons.  Minimum/maximum range: 0"-5.51" (0-140mm) Minimum/maximum transmission: 100-200mm. Approximate weight: 7100g. Use and precautions: 1. Insert the open end of the handle into the extraction shaft and tighten the shaft clockwise. 2. Adjust the jaws to maintain the correct distance and angle relative to the extraction position. 3. Rotate the handle to set the piston shaft in motion and use the jaw force to loosen the object. 4. The maximum stroke of this hydraulic tractor is 50mm. Take care when using it. You may need to try several times to ensure the object is still in the position that meets the hub's requirements. 5. To return the piston starting rod, simply use the grooved end of the handle and turn the return rod counterclockwise. 6. Do not overload. 7. Use (GB443-84) N15-545~45 oil, or (GB442-64) N20~-5 synthetic spindle oil. 8. The machine uses oil as its medium, so the oil and the machine must be kept together. 9. With a new or long setting, the hydraulic extractor can be charged two to three times to eliminate air space, as there is a lot of air in the cylinder and the rod may experience a small, sudden jolt during startup. Even if the extractor wheel is not used for a long period, you should move the toothed puller wheel 2 to 3 times per month. Contents: 1 hydraulic extractor, 1 handle, 1 2/3 leg extractor, 3 jaws, 6 screws and nuts, 6 connecting plates, 1 nasal adapter, 1 carrying bag.