868.3 MHz gate remote control – 2-pack, white, compatible with Hörmann systems HSM4, HSE2, HS1, HS4, HSZ1 and HSZ2

Compatible only with the following blue 868 MHz hand-held transmitters: HSE4-868-BS, HSE2-868-BS, HS4-868-BS5, BS5-86, HS1-868-BS, HSD1-868-BS, HSD2-868-BS

Note: Integrated sliding codes (blue LEDs)!

If the original remote control uses fixed codes (red LEDs), it will not work.

Compatible models per HORmann: HS1-868-BS, HS4-868-BS, HS5-868-BS, HSE2-868-BS HSE2-868-BS

Pro HORMANN HSE4-868-BS

Pro HORMANN HSP4-868-BS

Pro HORMANN HSD2-868-BS

Pro HORMANN HSS4-868-BS

Programming Instructions?

1. Press and hold the button on the new remote control. To program the code from the original remote control, press and hold the button, then press another button three times until the red LED lights up for 10 seconds. Then release all buttons.
2. Place the original remote control as close as possible to the left side of the new remote control.
3. Press the button on the new remote control. Copy the code until the LED flashes red and blue alternately. Check that the LED on the new remote control flashes blue. If not, try holding the remote control as close as possible to the original remote control. When the blue LED on the new remote control flashes rapidly, programming is complete. Release all buttons. Repeat the process for the remaining buttons. Method: Reset: Each button on the remote control is assigned a new radio code by following these steps: Remove the battery for 10 seconds. Press and hold a button on the remote control. Reinsert the battery. The LED will flash blue slowly for 4 seconds. The LED will flash blue rapidly for 2 seconds. The LED glows blue for a long time.
4. When the remote control button is released, all radio codes are reassigned.

Note: If the remote control button is released prematurely, no new radio codes will be assigned.

• Frequency specification: 868.3 MHz Channels: 4 Code: Rolling Code Battery: CR2430 battery included 868.3 MHz gate remote control