Attachable Storage Hooks, Garage Organizer, Practical Wall-Mounted Brackets, Mop and Broom Holder, with 20 Hooks, 4 Pcs 41cm Rails for Garden Tools, Garage, Shed, Basement, Storage Room

[20 Anti-slip Hooks] The storage hook is made of ABS material, which is rust-free, sturdy, waterproof, moisture-resistant, and corrosion-resistant. There are enough screws to ensure durability. Each rail measures 41 cm, and a total of four rails measures 164 cm. Each hook has a pin coated with anti-slip vinyl to prevent items from falling. [Load Capacity] Tool organizer with a high load capacity. The load capacity of the plastic pins and 5-shaped metal hooks can reach 8 lbs (3.6 kg) and 15 lbs (6.8 kg) when properly installed. [Space Saving] The 5-shaped metal hook design can hang various tools, such as a square, rake, shovel, broom, mop, and all tools with handles. The plastic hook can hang cloths, wires, cleaning products, etc. Save space and keep your kitchen, garage, and workshop tidy. [Packaging] 4x41cm ABS rail, 20 galvanized steel hooks with non-slip vinyl-coated pins, 20 pins, 4 connectors, 4 wall rail mounting holes, 20 screws, 20 pins. It is recommended to use a concrete or wooden wall for installation. Please ensure there are no cables or water pipes on the wall. [Easy Installation] Wall-Mounted Balaisis Carrier: The adjustable car crane system's ABS orbit features a fixed hole for custom installation. You can use the connector to extend the guide rail as needed, or you can use a connector to complete the guide rail. It is recommended to use a concrete or wooden wall as the installation location. Ensure there are no cables or water pipes on the wall. [Applicable and Adjustable] The storage system has a wide range of uses. It is very suitable for hanging shovels, spades, rakes, and other gardening tools in garages, basements, or sheds. Or used in workshops, cabinets, and other tool storage areas with rods. Installation Steps 1. Choose an installation position and mark the drilling points. 2. Drill 6mm diameter holes in the surface at the marked locations, then insert the dowel into the drilled holes. 3. Align the screw holes with the inserted dowel and secure the rails with metal screws. 4. Secure the hooks and plastic pins in the slots. NOTE: You can extend the rails with connectors as needed. Or close the rails with a connector.