Pro Automotive Short and Open Circuit Finder Tester Wire Tracker Circuit Finder DC 6-42V Short Circuit Detector Power Probe

【OPEN CIRCUIT LOCATION】 Powered by 2 x 9V batteries. It detects and alerts you immediately when a circuit is open. You can quickly and easily locate short circuits, open connections, broken wires, current leaks, and even trace wires. The LEDs on the transmitter and receiver indicate open or short circuit conditions.

【SHORT CIRCUIT CHECK】 You can also find intermittent circuit problems by bending wires or connectors and listening for a change in the receiver's tone. The 7-inch flexible probe helps reach wires in cluttered areas.

【SUITABLE FOR 6~42 VOLT DC CIRCUIT POWER】 It will work on all kinds of circuits with voltages between 6 and 42 volts DC. (such as those found in automobiles, trucks, tractors, boats, recreational vehicles, etc... With its wide operating voltage range.)

【OPERATION VIDEO】 Check out our video on the left side. Internally protected against overvoltage and overload. Built-in buzzer sound shows when an open or short circuit is detected. Comes with a storage bag for easy portability.

【QUICK AND EASY DIAGNOSTICS】 Check the continuity of cables or wires and diagnose the point of failure. Saves time, making your repairs faster and troubleshooting easier. I tried to find a fault in the car's electrical circuit.

Product Description

INTRODUCTION

This automotive wire tracer and short circuit finder is designed to identify and trace wires or cables without damaging the insulation. You can also use it to check for short circuits, locate open circuits, trace wires, identify wires, etc. A transmitter and receiver are included with the instrument.

HOW TO USE THE PROBE?

The receiver probe is constructed of coiled steel and can be bent as needed to reach wires in cluttered or difficult-to-access areas. Depending on the circuit characteristics and sensitivity settings, the probe will pick up the wire signal in a range of positions. However, for the best possible range, the tip of the receiver probe (black cap) must be positioned perpendicular to the wire being traced and either above or below it.

SPECIFICATIONS:

Receiver: On/Off button, Test button

Probe length: 7-inch flexible probe

Sender: Tone/Off/Continuity switch, Tone/Continuity LEDs, Red and black test leads, cable (61cm length, approximate)

Receiver Dimensions: 38.5 x 4 x 2.3cm (H x W x D, approximate)

Sender Dimensions: 6.5 x 5.6 x 2.1cm (H x W x D, approximate)

DC Voltage: Operates from 6 to 42 volts, Power: 2 x 9V batteries (6F22)

Please Note: This product set requires two batteries. Please install 9V 6F22 battery in both Receiver & Transmitter.

CAUTION

1. Only for use on DC voltage, don't connect to circuit exceeding 42 volts DC under any circumstances.

2. Do not use on AC voltage.

3. Do not use on any circuit directly or indirectly connected to AC lines or any other AC power source.

4. Do not use with any component or circuits of the ignition system.

5. Before using this device, check the vehicle's electrical wiring and disconnect any part or system sensitive to voltage and current pulses such as air bags, electronic control modules, etc

6. After you finish checking vehicle, make sure you have correctly restored all the connections which you disconnected.

7.Always follow the instructions and procedures indicated in the vehide's service manual before attempting to disconnect any part or subsystem of the electrical circuit.

INCLUDING: Inner-Carrying Case,Outer-Carton

1 x Automotive Short and Open Finder Sender

1 x Automotive Short and Open Finder Receiver

Carrying bag