Wolf Engineer's 5-Speed Pillar Drill, Precision Metal & Wood Drilling, 350W Motor

The Wolf Engineer's Bench 5-Speed Pillar Drill is built for workshops and maintenance departments that need consistent accuracy rather than a light-duty hobby drill. The headstock is cast iron and the base and column are precision-machined cast steel, giving it the rigidity to hold true under repeated use rather than flexing or drifting out of alignment over time. A 13mm keyed chuck on a JT taper drive shaft handles a wide range of bit sizes securely, while the twin 5-speed taper pulley arrangement, driven by a 350W capacitor-start induction motor, covers everything from slow, controlled drilling in metal to faster speeds for wood and softer materials. Changing speed is a case of loosening the tensioning bolt and repositioning the belt, with the pulley chart on the headstock removing any guesswork.

Safety features are built in rather than bolted on: a transparent chuck guard and enclosed drive assembly are backed by a micro-switch that cuts power the moment the top cover is opened, and a no-volt release switch stops the motor restarting unexpectedly after a power cut. The worktable tilts left or right to any angle and rotates a full 360 degrees around the column, so awkward or angled holes don't need the workpiece repositioned by hand. It's supplied with a 2.5" all-steel engineer's vice and fixing bolts for holding work securely during drilling.

Cast iron headstock, cast steel base and column – gives the drill the rigidity to hold accuracy under repeated heavy use without flexing.
13mm keyed chuck on JT taper drive – accepts a wide range of bit sizes and holds them securely for precise drilling.
Twin 5-speed taper pulley system – covers slow speeds for metal through to faster speeds for wood, adjusted via a simple tensioning bolt.
Micro-switch cover interlock and no-volt release – cuts power when the guard is opened and prevents the motor restarting after a power cut.
360-degree rotating, tiltable table – repositions the work rather than the operator, making angled and awkward holes easier to drill.