230V BENCH DRILL PRESS PILLAR DRILLING CROSS ZIPPER ZI-STB16T

Product received on time. Parcel arrived damaged, but effective interior protection. no damage to the product. Simple assembly. I added washers with the base fixing screws. No desire to screw directly onto the painted base. two holes for screwing the drill press base to the workbench. I would have preferred 4 holes and at the corners. when the warranty is over, I will make this modification. For the protective cover, the screws supplied for tightening the flange do not correspond to the housing. Screw replaced by an M5 with butterfly head. Belt tension adjustment is simple and effective with the floating intermediate pulley. A handle for tensioning would have been useful, I'll put one on. Assembly of the chuck to the mallet without problem. After checking, no unbalance detected, therefore less than 1 or 2/10. Silent. I will add a speed range identification sheet. The rise of the drilling table is not precise. But it doesn't matter, I'll mount a rip fence on it with carriage and stops for serial drilling. The big lack is the laser sight. All that remains is to install one for freehand drilling. It only remains to try the piercing capabilities.

good little product easy to assemble corresponds to what I ordered I do not regret my purchase

Not used enough, fulfills its function but noisy

Product corresponding to my expectations, I am very satisfied.

A good drill

This product seems correct But after 3 starts the switch no longer works. If this can happen it is very unpleasant not to be able to obtain this spare part. I am asked to return the complete product except it is installed assembled and fixed on a workbench in my country house where I only go on weekends except on weekends the carrier does not work. Add to that an announced delay of 3 weeks and I risk being out of order for several months knowing that this house is closed in winter from December to April.